Question about 2001 Nissan Almera Tino

1 Answer

Broken fan direction controller nissan almera

Fan direction switch is broken but the cold/hot and strenght are working well, do i need to change complete air-con panel or replacing just one switch will do the job?

Posted by Bart Simpson on

Ad

1 Answer

john stanley

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Nissan Master
  • 499 Answers

One switch will do the job

Posted on Mar 02, 2014

Ad

5 Related Answers

Anonymous

  • 109 Answers

SOURCE: upgrading nissan almera dipped headlights?

I would have the complete headlight circuit checked out by a competent tech before buying more bulbs.

Posted on Nov 21, 2008

Ad
onyeredson

Paul W

  • 404 Answers

SOURCE: Nissan Altima no cool air blowing or hot air blowing

Hi!
It appears we have an Air lock scenario and you will need to perform a system Bleed.
Park the vehicle on level ground, when cold remove coolant filler cap, start engine and leave to idle, turn heater on full and blower to max. When engine reaches operating temperature watch and listen near coolant filler, keep clear as gurgling and hopefully a boil over should occur. Top up with very warm coolant and wait as it may do it again.
Check for heat inside vehicle if warm replace coolant cap but keep an eye on temperature gauge as the ~Air lock may have moved on from heater matrix/core so proceedure needs to be carried out again from COLD.

Please press the Blue button to appraise my FREE Efforts, Thank You!
Paul 'W' U.K

Posted on Feb 24, 2009

Anonymous

  • 6 Answers

SOURCE: Nissan Almera Tino Diesel 2.1 - Temperature control not working

Hi there, very common on these vehicles, you need to remove the heater cotrols and check that the cable hasn't come out, usually the clips that hold the cables in place break causing the heaters to not work properly, Nissan do modified clips now to stop it from happening, it may need a cable too if its too far bent, hope this helps.

Posted on Jun 07, 2009

Anonymous

  • 40 Answers

SOURCE: Nissan Almera Air Con Advice

It may be low on refrigerant if the pressures are to low, the compressor will not engage.

Posted on Aug 01, 2009

Anonymous

  • 1 Answer

SOURCE: MY NISSAN ALMERA KEY LOST AND I NEED THE CODE TO GET A NEW ONE

i losted my nissan almera car key and i don't have the code to make a new key in my country ...it's now in lebanon exported frfom swiss

Posted on Oct 11, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cruze - hot air from driver side and cold from passenger


Do yourself a favor an take it to repair shop before you mess it up or hurt yourself !

May 14, 2015 | Cars & Trucks

1 Answer

Ac fan works but does not get cold


Hi there,
Check the air con drive belt is still OK.
Check to see if there is a slight change in the engine sound when the air con is switched on and off while idling - I'd get someone to do the switching while I listened under the hood.
If there's no change in sound (assuming whatever had to be switched on to enable air con to go, eg fan was operating) I'd check the fuse(s) for the air con.

If the fuse is ok, and you've already charged up the freon (not quite sure what you were saying there), I'd be taking it to an air con specialist.

May 26, 2014 | 1995 Buick Century

1 Answer

No heat from heater,no leaks just cold air


There is a flip panel in the air-con pipe system (cable controled) that controls the direction of the air blown by the fan through the heater or to by-pass the heater. Either the cable from ur controls (hot/cold) is broken or poped out of the groove/hole and has to be put back. It is usualy accessed from inside under ur dashboard. Pliz vote if it works. Good luck.

Jun 13, 2011 | 2001 Mitsubishi Diamante

1 Answer

2001 grand prix/ changed out dual climate/fan speed/air direction controls cause climate control knobs/slides were broken and was hot on drivers side and cold on passenger side-now can control pass side...


Probably the left side air temperature actuator is bad . electric motor that controls opening an closing of temp door in the HVAC case . No the computer doesn't need to be reset .
Temperature Valve Actuator Replacement - Left Side
Removal Procedure
Remove the left instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.
Remove the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gauges and Console.

Disconnect the electrical connector from the left air temperature actuator.
Remove the mounting screws from the left air temperature actuator.

Remove the left air temperature actuator.

Dec 05, 2017 | 2001 Pontiac Grand Prix

1 Answer

Audi A3 2tdi 2005 - hot air, cold air and air con not working -


You may need to reset basic settings for the control module using a scan tool , reading the logged faults stored in the control module is needeed also .

Jun 24, 2010 | 2005 Audi A3

1 Answer

Renault Clio Air Con Fan Problem - Wont turn off


Find Someone else,
Have Them Replace The Fan Selector Switch,
There Is Only 1 Fan In The System, Since You Can Select Between Defrost, Dash, Floor,
But Cannot Control Fan Speed/Shut-Off Fan.
I Would Replace The " Fan Selector Switch" Installed In Your Heater-A/C Controller Unit
Mounted In Your Dash.
Take Care God Bless

Jul 02, 2009 | 2000 Renault 181

1 Answer

2002 Nissan Altima - Heat doesn't get hot and doors get stuck


Did the switch break because it was stuck? If so, then yes, they will have to change actuators and doors. Does the fan work on all speed setting? If so then you do not need a blower resistor. The resistor pack only controls the current flow to change speeds of the fan.

Dec 05, 2008 | 2002 Dodge Dakota Club Cab

1 Answer

Radiator overheating


replace thermostat

Nov 14, 2008 | 1999 Honda CR-V

1 Answer

Heater blows cold, and fan switch only works on 4 and 5


working on 4 and 5 speed that the resistor that broken cold air you got to move the selector to see the motor that move the trap hot and cold sometime when the motor was not move to the hot side for a long time its jam the motor on the passager side under dash put to hot and gently tap the motor tanks pierre

Oct 24, 2008 | 2002 Chevrolet Malibu

Not finding what you are looking for?
2001 Nissan Almera Tino Logo

Related Topics:

321 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...