Turn of the airbag light

It's your Electronic Stability System. It may be malfunctioning because of the cold temperature or triggered by another malfunctioning system. You need to take it in for a diagnostic investigation.

DID YOU REMOVE AIRBAG FUSE OR DISCONNECT NEGATIVE BATTERY CABLE TO DISCHARGE AIRBAG CAPACITOR DISCHARGE BEFORE YOU REPLACE IGNITION SWITCH KEYLOCK CYLINDER. CHECK MAKE SURE YOU INSTALLED AIRBAG FUSE OR IF YOU DID DISCONNECT NEGATIVE BATTERY CABLE.WHEN YOU RECONNECT NEGATIVE BATTERY CABLE.WITH IGNITION SWITCH ON POSITION FOR MINUTE THE AIRBAG LIGHT SHOULD TURN OFF.IF NOT HAVE GARAGE OR DEALERSHIP CODE SCAN AIRBAGS SYSTEM SEE WHAT CAUSE SRS AIRBAG LIGHT TO FLASH ON COULD HAVE FAULT IN SYSTEM..

It may have bad module.

Hi.

The airbag light means that a problem with the airbag has been detected and that there is an error code stored in the airbag control module. The code will tell you what is wrong with the airbag. The code can be read at the nearest Lexus dealer, you will be charged a fee of $80.

Sometimes the light can be reset by disconnecting battery for ten minutes. Disconnecting battery will also delete the error codes stored. If the light comes back when you connect back the battery, that means that the problem is still there, and that the airbag control module detected the problem immediately.

Regards.

Ginko

Guys! Are you readying your airbag system after messing around with your truck?

I've seen airbag lights come on for man reasons, faulty sensors, connections, replacing RADIOS! Removing seats!! All sorts of reasons. Personally I bought my QX56 with the airbag light blinking. Drove me crazy for 24 hours till I decided to reset it n see what happened. It takes two minutes to do. No tools.

1. Turn key from off to on. (on meaning all your dash lights are on but your not cranking the motor)

2. Watch the airbag light closely. It will stay on for a few secs. and then as soon as it blinks off (the start of the flashing), turn the key off instantly.

3. Count to 5 (1 Mississippi, 2 Mississippi . . . .)

4. Repeat steps 1-3 two more times until you have done the cycle three times.

5. Now turn the key on and watch the light. It will start blinking in a different, slower manner. This is diagnostic mode. You can watch this for a little while, no hurry.

6. Now turn the key off again, Count to 5 like in step 3 again, and turn back on. If the procedure worked, the airbag light will not be flashing.

i know all about the vegas heat. i live in henderson. the alternator is going out. the regulator is internal so you have to replace the whole alternator.

We have the same problem. And we've tried everything but disconnecting the battery and drove it so maybe I would turn of but still nothing. If you took it in or found out the solution could you please let us know thank you

By turning the key on with the seats removed you have put a code into the airbag module.
A good scan tool CAN RESET the airbag module in your vehicle back to factory settings..

If the car ran and got you home after a jump start I doubt the alternator is bad. Check your battery. And remember never ever disconnect the battery cable with the engine running.

seems to be my mantra this time of year (condensation). check the relay for the airbags... be advised because it is the airbag... to prevent accidental deployment of the airbag when you replace the relay... unhook the battery while you do that.


Robert