Interior lights stop working after i changed front 2 bulbs

could be bulbs in the interior lights

Check fuses and both bulbs... in cab fuse box. ..

may have to purchase an electrical shopm manual for more information

usualy you turn the ke switch on the on set hold the reset mile button turn key off but still hold reset button then turn key to the on set again and hold the mile reset button for 10 to 15 seconds or untill the check engine light comes off . it worked for me on an older model nissan hope this will help out

sounds like an electrical problem

LOOK IN GLOVE COMPARTMENT FOR OWNERS MANUAL LOOK IN BACK INDEX OF THE MANUAL LOOK FOR BULB REPLACEMENT.IT WILL SHOW AND TELL YOU HOW TO REPLACE BULB.

Do you has an after market (non-factory) alarm system?
==
Locate and check the alarm module's inline fuse(s) and relay(s)
Open covers and check every dome light bulbs.
Clean the door and rear hatch electrical contacts.
Some interior lighting system has a "slow dim" or "theater" lighting module. Check for loose connection at the module.

Fallow what your eyes take you. Find the ligth change the bulb. Very easy.

Set parking brake and use jack stands if you raise the vehicle.
1. Remove engine front undercover.
2. Warm up engine. This is need for the oil to flow freely when draining.
3. With engine stopped loosen oil filler cap and then remove drain plug.
4. Drain oil into a drain pan.
5. Install drain plug with new washer. Tighten to 25 ft-lb.
6. Remove oil filter using a filter wrench.
7. Make sure the surface is free of foreign materials.
8. Apply engine oil to the seal and install your new Nissan filter. Tighten filter 2/3 turn after contact with surface or 13 ft-lb.
9. Refill engine with 6 quarts of oil.
10. Start engine and check for leaks.
11. Stop engine and check oil level and add to the full line.
12. Reinstall engine front undercover.