Reattach clips in door handle
SOURCE: 98 Jeep Wrangler door handle won't open door
there is a metal bar inside that clips into the handle they come off all the time there is a plastic clip that hold the 2 together it most likely has fallen off and into the bottom of the door you can put it back together easily if clip cannot be found you can buy them at local parts store for a couple bucks..hope this helps
SOURCE: How do I replace the interior LH door handle 97 Jeep Wrangler?
you will need a t-20 or t-15 torx bit driver to remove 2 screws holding the handle this is all that holds them on, on once you have a replacement handle it is easier to remove 2 lower screws on the door panel and unsnap the door panel to loosen it this will allow space making it easier to reinstall new handle just slide each end into the slot and reinsert 2 screws to not fully tighten until door panel is snapped back in. the panel is held on with clips and can be released using plastic pry tool around door panel edges.
SOURCE: Jeep TJ Wrangler Outer door handle removal
The handle is held in place by two vertical wedges on both sides of the handle. To remove just force the wedges up with a hammer and screwdriver (be careful of the glass). Putting them back in is very difficult. I would suggest making the bends or adjustments with it installed so you'll know exactly how much you need. I hope this helps.
SOURCE: 1998 Jeep wrangler
Remove the inner door panel and check to make sure that the linkage rod that goes between the outer handle and the latch is connected. It's possible that the plastic end clip broke.
SOURCE: How do I install a driver dide door handle on my
Inside handle, no, outside yes, to access nuts/bolts on back side.
287 views
Usually answered in minutes!
×