Front axel will not go back in after seal replacement

Keith the seals will need replaced, take into a shop and have a tech give estimate for repair. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
half shaft seal replacement Google Search
How To Install Replace Front CV Axle Shaft 2002 09 GMC Envoy and XL XUV
Part 1 How To Replace Front Axle Shaft Seal RH Front Chevy GMC
CV axle replacement Subaru Outback 2000 Legacy Forester Install Remove...

2001 Chevy Tahoe Heat Problem - Tahoe Forum

www.tahoeforum.com > ... > Technical Discussions
Dec 5, 2008 - 10 posts - ‎7 authors 2001 Tahoe, the front heater blows a little hot air when the car warms up and then blows cold air. The rear heat seems to work fine. I changed ...

Rear AC blows hot air - Tahoe Forum - Chevy Tahoe Forum

www.tahoeforum.com > ... > Technical Discussions

Jul 14, 2008 - 10 posts - ‎5 authors
On my wifes 03' Yukon the rear air conditioning blows hot air no .... Pull the panel off and look at the hot/cold actuator shown in the picture.

Hi,if you are talking about the drive shaft cv boot,there is a vidio on you tube showing how to change the drive shaft same perseger,hope this is helpfull,all the best,its a easy fix.

Front Transmission Pump Seal ?

Have to pull the trans for that

Google the exact steps...you'll be amazed what you find.

I had this problem with a 1997 suburban and a 1999 tahoe. I fixed it on the suburban by replasing the complete light assembly, and on the tahoe i just replaced the circuit board were the light bulbs and harness plug in its easy and inexpensive. good luck!

It involves removing the trans from the vehicle pulling the pan off the bottom of the trans removing the tcc solenoid from the pump then removing all the bolts from the pump and pulling it out the front ... chances are though if the pump is bad so is the rest of the trans .. if its just a convertor seal leaking u need to drop the trans pull the convertor pry out the old seal from the pump and replace it with new .

Probly broken axel,seal or linkage.

you need to pull off wheels,brakes, rotor /unit hub bearing, both axles and intermediate shaft, as well as the vac disconnec ton the front axle tube. if only the right side leaks then only then only pull the right axle and intermediate shaft and vac disco. it is a trick with a miller tool to replace the seal. the left side seal is inside the diff and the carrier has to come out to replace it. pete