Remove ignition switch

Likely the ignition switch is not rotating completely into the off position. If your key is extremely worn, it may be possible it can be removed without the switch exactly in the off position. Suggest trying a different (less used) key and see if problem goes away.

Else try to make sure it is in off position (clock off) before removing key. If you find that's the problem you may need new keys or switch or both.

hi.it can be your ignition switch.there is a switch in the ingnition you can normaly here it making a sound when you remove key it can be that its sticky.you can try cleaning it with a lobe spray or something to see if it loosens up.hope this helps

Could b faulty ignition switch check multiplug back of switch first

Any codes,try to check for codes go to auto zone they can check for free.

Electrical port of the ignition switch is defective.

That's always on (displaying) and the only way to shut that off is by removing an internal rechargeable battery. Even when you unplug the wire harness it will store the odometer reading although the time will be lost.

When you buy a new speedo head used or brand new, it should only have 100mi or less so you can write your original odometer readout to the replacement. Above that you can't write and eventually have to start from 101mi as your reading.

Yes.They have delay relay.

System operation
System arms 5 seconds after switching ignition OFF. Switch ignition ON. Ensure clock LED illuminates for 3-5 seconds. If LED flashes rapidly at regular intervals for approximately 1 minute, then flashes at irregular intervals: Key code not recognised. Remove key and try again.
Programming
When
System malfunction: LED illuminates for 1 minute, then flashes at irregular intervals. Key(s) added or replaced.
NOTE: Replacement keys MUST have blue mark. Keys with red mark are NOT compatible with this system.
How
NOTE: Programming method using vehicle keys can be deactivated using diagnostic equipment.
Obtain 2 programmed keys (A and B). Insert key A into ignition switch. Turn ignition switch to position II. Wait 1 second. Switch ignition OFF. Remove key A. Insert key B into ignition switch within 5 seconds. Turn ignition switch to position II. Wait 1 second. Switch ignition OFF. Remove key B. Within 10 seconds: Insert key to be programmed into ignition switch. Turn ignition switch to position II. Wait 4 seconds. Switch ignition OFF. Wait 5 seconds. Start engine. If engine does not start and clock LED flashes: Switch ignition ON. Wait at least 20 seconds. Switch ignition OFF. Repeat programming procedure. Repeat above procedure to program remaining keys. Keys can also be programmed using diagnostic equipment

To reset the message displays, turn the ignition switch on. Press and hold the odometer reset button "A" located below the speedometer. Turn off the ignition while holding the button. "OEL" will display on the indicator. Press and hold the lower digital clock reset button "B" until five dashes appear in the display. If needed, press the odometer reset button until "IN 01" appears and then press the clock reset button until five dashes appear. If needed, press the odometer reset button until "IN 02" is displayed and then press the clock reset button until five dashes appear. To exit reset mode, turn the ignition switch on and when "IN 01" appears, turn the ignition switch off.



1. Switch ignition ON.
2. Press and hold odometer reset button below speedometer.
3. Switch ignition OFF and release odometer reset button. OEL will now
display.
4. Press and hold the lower digital clock set button or the analog clock set
button until five dashes (-----) appear in display.
5. If necessary, pree odometer reset button to proceed to the IN 01 display
(15,000 mile maintenence) and reset using the clock button.
6. If necessary, repeat procedure to reset IN 02 (30,000 mile maintenence)
display.
7. To end reset mode: switch ignition ON; when display IN 01 appears, switch ignition OFF.

Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.