Perform the following
Turn the ignition off
Press and hold the milometer push button (the button for reset the miles mostly the right hand push button on the dash)
Turn on the ignition (do not start the car!)
Wait for the display countdown to reach 0
Release the milometer push button
Turn the ignition off.
Turn the ignition on and check that the correct mileage till the next service is displayed
For si1968: Procedure for Boxer spanner light it is slightly different but not complicated. However, you should carry out any service that is due and then do a re-set procedure as follows:
* Place the ignition key in the MAR position (1st notch) and wait until the spanner stops flashing,
* Press the trip recorder re-set button for five seconds.
-------The distance remaining to the next service is displayed-------.
* Press the trip distance recorder zero reset button for five seconds to store the operation in the memory.
Important: after this operation, if you wish to disconnect the battery, lock the vehicle and wait for at least five minutes, otherwise the zero re-set will not be registered.
Sorry for late response but you should put your question in problems and not in solutions like here.
For Boxer service light reset:
* Place the ignition key in the MAR position (1st notch) and wait until the spanner stops flashing,
* Press the trip recorder re-set button for five seconds.
-------The distance remaining to the next service is displayed-------.
* Press the trip distance recorder zero reset button for five seconds to store the operation in the memory.
×
Hi,
i have a 2006 boxer with the 2.2hdi engine. just tried to reset the spanner using the method above but the spanner is still there.
any suggestions please?
My odometer is not working at all. I serviced the car and it worked for a bit then stopped again. any ideas?
SOURCE: Peugeot Partner Van Brakes Drive Shaft
Check both sides of the discs if they are ok.If yes then quite possible that there is lots of brake dust between the discs and pads.
SOURCE: Peugeot Partner Fuel Pump Problem.
If that connection is leaking, then that is more than likely the problem. If fuel is leaking out, then air will leak in. When the van is left overnight, the fuel will run back down the fuel line to the tank, leaving air in the pipe. The fuel system must be completely air tight. Try slapping some grease around the connection and see if it starts in the morning. if it does then replace the connector and you have fixed the problem.
TL
SOURCE: cannot take casing off front side light bulb
I want to change the side-light bulb on my Citroen Picasso off side front. I can get the near side one off, but find it difficult to turn the bulb holder inserted in the head light lens. Should I use some outside help like a HAMMER? Pete
8,392 views
Usually answered in minutes!
×