Himy corolla car s.e.saloon model 2003 i have the problem backfire and broken manifold than i can changed manifold and overhaul engine but again engine have same problem and manifold is leak.so any suggestion would be greatly appreciated, Thank you

Paul Thoegersen

• 95 Answers
• Posted on Jan 08, 2009

SOURCE: where is the engine number situated in 2003 corolla toyota saloon

The engine model is on the emissions label under the hood on the hood. This the number you need to order parts etc... the actual serial no of the engine is usually not required only VIN and eng model.

SOURCE: newly overhauled toyota corolla 2e engine emits black smoke

I have toyota corona 3s engine it smokes black and fuel consuption is high we have changed the engine oil and cylinderhead gassecate but still black smoke is comming what should i do

Duane Wong

• 6826 Answers
• Posted on Oct 09, 2010

SOURCE: where is water pump and drive belt located on

Water Pump Removal & Installation To Remove:

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Drain the engine coolant.
3. Remove the right lower splash shield.
4. Remove the drive belt
   
   
5. Remove the 6 water pump mounting bolts. Remove the water pump and O-ring (except XRS).
   
   
6. Using special tool 09960-10010 or equivalent, remove the water pump pulley bolts and pulley (XRS).
7. Remove the 6 water pump mounting bolts. Remove the water pump and O-ring (XRS).

1. Install a new O-ring on the timing chain cover.
   
   Note: Bolt lengths are indicated in the illustration bolt (1) 1.18 inches (30mm) bolt (2) 1.38 inches (35 mm)
   
2. Install the water pump (except XRS).
   1. Tighten the mounting bolts (1) to 80 inch-lbs (9 Nm).
   2. Tighten the mounting bolts (2) 8 ft-lbs (11 Nm).
3. Install the water pump (XRS).
   1. Tighten the mounting bolts 80 in lbs (9 Nm).
   2. Install the water pump pulley using special tool 09960-10010 or equivalent. Tighten the mounting bolts 11 ft lbs (15 Nm).
4. Install the right lower splash shield.
5. Install the drive belt.
6. Fill the cooling system.
7. Check for leaks.

SOURCE: '98 Nissan Sentra GA13 guzzles

I encountered a very similar problem before. Have your carburetor redone. I also spent a lot trying to fix that kind of issue before with the car I'm using (also with ga13ds). I overhauled the carburetor 2 times using repair kits but there are still the same issues and at one time things became even worse. Bring it to a mechanic who works with nissan (not necessarily in the service center) and/or is specializing in carburetors because there are a lot of things that may go wrong inside a carburetor. I brought mine to an expert in Evangelista Makati, Philippines ( well I guess your from the Philippines because I could not find ga13ds from other countries unless I'm wrong) and it only took about two hours without even buying parts, just some elbow grease, smashing, scratching, and some salvaged parts from other carbs- the whole process cost me Php1,800 plus travel expenses. Also, buy a good air filter and make sure that your air cleaner assembly is working properly, these kind o issues are caused by accumulated dirt in the system and it slowly destroys the carb. After having all the repairs done, invest in one aerosol can of carb cleaner and use it on your carb maybe about once a month (I do it that often) it keeps performance as close to optimum as possible and prolongs the carb so it will take a while before it needs to be overhauled again. The MPG however, may not be the same as before. Since it's an old engine and engines tend to consume more fuel proportional to its age (according to my mech engineering undergrad brother), the MPG may be more by a bit and it is also affected by the engine overhaul, because of a lot machining and making things larger by a bit, the engine will increase cc (I think) by an amount that will also affect your MPG.
There..I hope this helps..Good luck! I love these old carbureted engines, they're so simple to tinker with.
If you're from the Philippines, the man to look for is Mang Vising in Bgy. Bankal, Makati. Just near the INC church there in Evangelsita. Coming from EDSA, turn right just before you reach the INC church and just ask around.
God bless!

SOURCE: 1998 bmw 740i check engine light on, smokes when

1998 BMW SMOKING WHITE SOME TIMES