The 2006 LS has a parking brake that is controlled electronically. When power is lost to the car (battery disconnected etc.) the brake has to be reprogrammed to relearn what position it is in at the time. When this happens the info center up by the speedometer reads "foot on brake." If you depress your brake pedal the message will change to the next step and will walk you through the reprogramming. I believe you activate the parking brake next and then turn it back off and drive around the block, activate again, turn off again and shut down car. When you restart the car the parking brake will be reprogrammed however if you overlook the foot on brake message (like I did for a while) the car will be confused about whether the parking brake is on or off for awhile. This whole process is listed in the owners manual in case I have forgotten any of the steps. Hope this helps.
SOURCE: brake lights blows fuses
Please check the brake light wiring there must be somewhere where the live wire is touching the body (earth -) and thus the blowing of the fuses.
Since the plug in had melted so must have the wires insulation top melted somewhere and its now shorting.
Hope this helps.
SOURCE: stuck in park
manually move the brake switch you installed and have someone check if its comes on at the back...if not ..test for voltage at LG/RD wire- both terminal and wire- if no voltage = Fuse #10/ 20A , #20/ 7.5A, #22/ 20A at the CJB, if good test for voltage at the sockets- both terminal and wire- ......if you get BRAKE lights and still can't move the shift lever... look on the steering column at the SHIFT LOCK ACTUATOR and test that or replace it....hope this helps you..GL
SOURCE: the abs light ativates on dry road conditions & lite baking lefts
YOU HAVE A DEFECTIVE WHEEL SPEED SENSOR, TO DETERMINE WHICH OF THE FOUR IS DEFECTIVE HAVE FORD DO A SYSTEM TEST FOR THE ABS TROUBLE CODE THAT SETS WHEN THE LIGHT COMES ON.
SOURCE: My 97 Licoln Town car 4 way flashers, turn signals
Replace both lights at the back of your car. The fact that you have steady non-flashing lights at the front and no lights at the back is a troubleshooting tool to let you know the back lights are bad.
874 views
Usually answered in minutes!
×