I have a 1999 Audi A6. I am unable to reset the driver's side seat memory. It always goes back to a weird seat position so I am forced o manually adjust. I know how to reprogram the seat properly so I know it is not me. My guess is that I need to replace a part but I do not know if it is the memory settings on the door or is it another part (maybe under the seat).
SOURCE: audi timing belt
It's a complicated job, and usually takes about 8 hours to do the full service if you're familiar with the car's mechanicals, you have a good array of tools (air tools help a lot), you're familiar with what you're doing, and with how to disassemble everything (including removing the front of the car - I'm not joking). There's more to the job than just the belt too - you need to replace the timing belt, timing tensioner, water pump, thermostat, serpentine belt, and serpentine tensioner. If your cam seals are leaking (which is also known to happen), you'd need those and plan for a couple more hours as well, due to the care that must be taken not to scratch or score the cam end caps.
SOURCE: My infrared remote does not work. I have an Audi A6 1995
Do you have memory seats as well? If so follow these steps I am going to refer to the keys as A and B as you have 2 of them
1) Unlock car with key A
2) Turn ignition into ON position with key A and roll down the window
3) Point Key B at IR Sensor and Click twice (perform both clicks under 5 seconds)
4) Turn off ignition and pull Key A out
5) Turn ignition into ON position with Key B
6) Point Key A at IR Sensor and Click once
7) Turn off ignition and Pull Key B out
Key A should be programmed as the Master Seat Program and Key B should be programmed for the Secondary seat program
So when you set your memory seats Key A is for Memory Position 1 and Key B is for memory position 2
if you don't have memory seats then you only have to point the receiver at the sensor and click once. That should just sync the IR Frequency and Codes
SOURCE: how to remove rear seat from 2001 Audi allroad
Not 100% sure on yours but normally you'll either have a couple of bolts way down under seat cushion at front, near floor, or in some cases, you have to push seat cushion back toward rear window, hard & lift, to pop it out of notched catch under it.
SOURCE: HOW TO REMOVE FRONT SEATS AUDI A6 YEAR 2000
You need to access bolts that are bolted to the floor, disconnect wiring, move the seat forward and look from the rear seat down under, you will see bolts..
894 views
Usually answered in minutes!
×