Pacifica fold down seat option

Check the heater fuse, if the fuse is ok then the element need to be replaced

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tony_a41fa0b801734e2f

check the fuses front the driver near the battery

To fold-down rear seat on 2007 Chevy Malibu, follow these steps:
1. Open the trunk
2. Pull on one or both the handles located on the upper side of the trunk
3. The handle located on the driver's side will unlatch the bigger part of the read seat
4. The handle on the passenger side will fold down the smaller portion of the rear seat.
5. Once done, you will have a seat that's nicely folded down.

Are we talking about Nissan Notes here? I have the same problem with my 2006 Note where the larger of the 2 split seats in the rear won't fold down. It doesn't have any side latches or boot straps and yanking it hard doesn't work either. I can't see any options other than complete removal of the whole rear seat assemby.

If you pop the back panel off your seat on the bottom right hand side you will find the motor for the recline and it has one T30 bolt and a shaft going through the center witch if you remove the clip on the right side of the shaft it will slide out far enough to remove the motor.Follow the wire down to the bottom of the seat almost to the floor the plug is there. When putting in the new motor it is easiest to have some one help you by pushing the button back and forth to line up the shaft and bolt hole.hope this helps you out.

The third row seats have pull tabs inset into the top of the seat backs. The pull tabs are connected to wires that when pulled will release the catch that holds the seat in place.
The middle seats have the typical lever that on the outside bottom of the seat that you would use to adjust a seat manually in many cars.

Okay so im just going to start from the seat being upright in a normal riding position.

1. You need to fold the head rests first. Pull the black tab under both headrests. They should spring into a folded position.

2. pull the side seat lever (on the door side of the seat). This will fold the top/back support down to an angle.

3. There is one more lever on the backside of this seat. Its in plain sight on the angled portion of your seat. Lift the big plastic lever.

4. While keeping the handle lifted, grasp the back of the seat and pull it torwards the front of the car. The seat should come unlocked and roll forward and down more towards the floor. If you have a bunch of junk on the floor, it obviously wont work. clear the path and the seat will fold completely flat.

Also, your drivers seat and front passenger seat cannot be all the way back, they need to come forward some in order for the second row seats' head rests to clear and fold flat.

third brake light wont work it connected to a circuit board?

try at the top they made them with a lever or flap

Instructions with pictures to follow: