- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
this is what your check engine light was telling you. code 12 battery input was disconnected within the last 50 key-on cycles. code 54 no camshaft signal detected during engine cranking. code 55 completion of fault code display on check engine lite. hope this will help you!! note: camshaft sensor is located in distributor on 3.0liter engine and on a 3.3liter and 3.8 liter engines its located next to the thermostat housing.
The flashing check engine light would mean that the engine is misfiring, If you have a scanner, use it on the diagnostic port of the engine to check for the error code to get which cylinder is misfiring and if there are other errors that needs to be checked.
your van has an obd1 setup with dodge all you should have to do is turn key to ign to off 5 times without starting vehicle and the check engine light will flash the code for example it will start off with a code 12 i believe saying the computer is functioning the check engine will flash 1 pause flash 2 pause and will repeat a total of three times just write down all the codes when it gets to code 55 it is done hope this is helpful
Engine? Those flashes should be 2 digit numbers . Cycle key, on, off, on, off, on & leave on & recount those flashes. Example: 3 flashes, pause, then 3 more is code 33. Or 2 flashes, pause, 4 flashes, is code 24. 5 flashes, pause 5 more, is code 55 which means end of message. Then get back.
Check for vacuum leaks. Cycle key, on, off, on, off, on, and see if check engine light flashes out codes. always 2 digit number with short pause in between. for example: 2 flashes, pause, 2 more flashes, is code 22. Write them down & get back to us. Code 55 (5 flashes, pause, 5 flashes, is end of message (codes).