Question about Land Rover Discovery

Open Question

Where is the flasher relay location on a 1998 land rover discovery

I need to find which relay controls my turn signals and my hazards. I cant find any clear diagram of what each of my relays controls

Posted by Anonymous on

Ad

5 Related Answers

wilsodfarm

Donnie Wilson

  • 986 Answers

SOURCE: 1998 Dodge 2500 pickup turn signals, hazards

There is a conector box on the left side of your steering wheel on the colum loosen it and check your wires I bet when you just loosen the block they will start working,I hope this helps you

Posted on Oct 08, 2009

Ad

Anonymous

  • 1 Answer

SOURCE: Flasher Relay location- 1998 Mazda B3000 pickup 4x4

On my 2000 Mazda B3000 it's up underneath the dash right by the steering column, like they said, blue plastic square relay

Posted on Apr 07, 2010

Ad

Anonymous

  • 1 Answer

SOURCE: Land Rover Discovery TD5 1999. Where is the Fuel Relay Switch

In the engine fuse box under the bonnet ,relay is the closest one to the front of the vehicle ,about £7 to replkace

Posted on Jun 09, 2010

techbuster

INDIRA KUMAR

  • 5081 Answers

SOURCE: Location of Relay-Fuel Pump Land Rover Discovery

Behind right hand trim kick panel located on the top right hand side...

Check this picture alsoeaf8b18.jpg

Posted on Sep 30, 2010

richochet

  • 1026 Answers

SOURCE: where is the turn signal relay for the 1994

if you turn on each item you should hear or feel them working

Posted on Oct 07, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 Jeep Liberty , hazard lights not working turn signals out too. turn signals are fused separate left om one fuse right on another, any ideas


You need to check the power with an electrical screwdriver. Start with the turn signals. Did the bulbs blow.? If so there is a serious electric fault and it will get worse. Has the jeep been through flooding? Thearth connections may be damp. You may need to use a hair dryer to fix them.

Jan 15, 2018 | Jeep Cars & Trucks

1 Answer

Turn signal relay 2007 Avalanche ltz


There is no turn signal relay or flasher , Computer controlled by the BCM - body control module .
Turn Signal/Hazard Lamps
When the turn signal switch is placed in either the left or right position, a ground signal is completed from the turn signal switch to the BCM. When the hazard flasher switch is activated, a ground signal is completed from the turn signal/hazard switch to the BCM. The BCM then sends an ON-OFF voltage signal through the fuses to the appropriate turn signal and side repeater (export only) lamps or to all of the turn signal fuses for hazard operation. The driver door switch and passenger door switch also receive voltage from the BCM turn signal supply voltage circuits for the mirror turn signals. The door switches have no function or control of the mirror turn signals other than a pass through connection for the circuits. The audio chime is also activated when the turn signals are ON. The instrument panel cluster (IPC) receives the signals to activate the turn signal indicators over the GMLAN serial data system. When the hazard switch is pressed, all turn signal lamps will flash including both IPC turn indicators.
This is something best left to a qualified repair shop that has a professional type scan tool . Could need new BCM , which would need programming . Scan tool would be able to check switch inputs for BCM .

May 22, 2016 | 2007 Chevrolet Avalanche LTZ

1 Answer

Where is the blinker relay in my 2011 Chevy Equinox.


PCB Relays
This vehicle is equipped with the following printed circuit board PCB mounted relays.
• High beam
• Low beam
• DRL
• Fog lamp
• Park lamp
• Stop lamp
• Horn relay
They are directly soldered to the underhood fuseblock circuit board. A failure of one of these relays will require the whole under hood fuse block to be replaced.

Turn Signal/Hazard Lamps
The body control module (BCM) is responsible for controlling the turn signals and hazard lamps. When the turn signal switch is placed in either the left turn or right turn position, the BCM receives a signal from the turn signal switch. The BCM then sends an on-off voltage signal to either the left or right turn signals and their instrument panel cluster (IPC) indicator. When the hazard switch is pressed, the BCM receives a signal from the hazard switch. The BCM then will send an on-off voltage signal to all the turn signal lamps. All the turn signal lamps will flash including both IPC turn signal indicators.

Vehicles are just not the same as they use to be. Electronics !!!!!

Sep 25, 2015 | 2011 Chevrolet Equinox

1 Answer

2008 envoy Denali right turn signal and right hazard quit. replaced relay worked for 20 minutes of driving then right turn and right hazard quit again??? LEFT SIDE IS FINE


Sounds like you have a wiring issue ! Maybe when you installed the turn / hazard relay you moved the wiring harness in such away that made it work. Grab the wiring harness an do the wiggle test an see if it works . Mite have lose connection where the relay plugs in, close the terminals a little bit. I don't know what you know about electrical systems on automobiles or I'd tell you to do a voltage drop test to find the problem . Need volt ohm meter an a wiring diagram to do this test. Electric Testing Techniques You Need to Know

Feb 28, 2015 | 2008 GMC Envoy Denali

2 Answers

I have a 1998 ford windstar mini van


do your signals work ? listen when signal is on the (clicking noise) when you find that flasher relay is next to it.

Aug 29, 2014 | 1998 Ford Windstar

2 Answers

No turn signals, everything else works including hazards, took the box out under the dash where i was told the relay would be, and yes theres like 6 relays but they dont come off the board....


Actually there is a relay however it is not an individual part. The turn signal relay and the hazard relay are in the LCM (Lighting Control Module). This is expensive to replace however you should test the multi-function turn signal switch first as I am having the exact same problem with my 95 Crown Victoria LX. If you go to any parts store they will tell you that it is just a relay and sell you one for the newer Crown Victoria models. However in the 95 to about 2002 models they employed the bad idea of the LCM.Good luck.

Jul 26, 2011 | 1996 Ford Crown Victoria

1 Answer

1989 Lincoln Town Car Turn Signal Relay location


Thats strange they should be on the fuse panel ! Are you sure !!!!

Aug 12, 2009 | 1989 Lincoln Town Car

1 Answer

Can't find turn signal relay.


check the hazard switch on some cars its part of the hazard switch or if the conection is bad they none of it will work.

Mar 16, 2009 | 1994 Chrysler LHS

1 Answer

2004 F150- Hazard Flashers dont work, turn signals do work


try replacing the hazard relay it should be under the dash try turning it on and off with your head down by the floorboard to pinpoint the right relay and the location. you should be able to hear it easily. hope this helps.

Dec 04, 2008 | 2004 Ford F150

2 Answers

Hazard Lights working. Indicators will not operate/flash


The Hazard and turn signals share the same relay module located in the dashboard behind the hazard switch. Remove the trim by prying from the sides (Either side of the Cup holder drawer and Card drawer). Pry the hazard switch assembly out from the dashboard. The relay is part of the hazard switch assembly.

Unclip the wiring terminal from the relay. replace with appropriate relay. Part costs under $50.00 delivered from Import Parts Specialists.

Nov 02, 2008 | 2003 Audi A6

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...