Hi i changed the motor of wiper I have the same problems my wiper stop on the middle. when I start my switch the wiper goes down and up and stop again on the middle... I get off my wiper and if I put on right position the wiper goes down again but on my truck body. Do you know if existe a relay or if you have others solution?
You will need to replace the wiper motor.
Testimonial: "I changed two motor and I haved same problem!!! What is the solution???"
SOURCE: 2005 Dodge Ram 1500 4x4 - Intermittent wiper problem
There is a fault with Wiper stalk have got same prob with my 2006 ram 1500 5.7l hemi they should change under warrenty are with mine
SOURCE: 04 dodge ram 1500 wiper arm goes down before going up
remove wiper arms at the shaft, right at the cowl. each will have a nut on them but it is covered by a piece of plastic that will snap up for access. take nuts off and remove wiper assembly. turn key on turn wipers on make sure shafts turn when on, then turn off the shafts to stop in park position. then reinstall wiper assemblies in their park position .
SOURCE: 92 dodge 318 truck engine runs til you stop, then stalls when put
Then i think i'd be dumping some soapy water on the intake gaskets checking for leaks. ANd wiggle the **** out of all vacuum hoses. ( you probably did that) And if there aren't any, your cam could be tired. You got a tough one there. Hard to figure with a keyboard.
SOURCE: Rear wiper motor not working
most likely the wiper motor is bad the second wire sould be a ground if you set meter to ohms you sould be able to get a low resistance to any good ground on the vehicle if the hot wire is hot any time key is on the bcm is controling the ground to operate moter and you should have a steady continuity on the ground side with switch on the fast postion an it will read on and off in the intermitant postion if both wires test good motor is bad when you replace motor let it cycle and shut it off before installing the arm on it
359 views
Usually answered in minutes!
×