Question about 2000 GMC Sierra 3500

1 Answer

94 chevy truck with a 6.5 turbo diesel

Wen i put my truck into to gear it wont go unless you gun it and roll back and front wards till u can get goin then u cant get over 1000 rpms . so it dosent shift to the next gear at all.

Posted by steven_holub on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Where do i get a chip for a 94 gmc k1500 sle 6.5 turbo diesel

Posted on Jan 09, 2011

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I changed the front hubs in my 94 rodeo 2.8litre turbo diesel 5sp manual 4x4 and nowe cant get reverse or any other gear but 1st or second wat could be wrong?


When you say U changed the front hubs on the 4/4 WHAT did you change what was differant to the 94 hubs as if you only changed the hubs and backing plates/brakes etc and nothing else Then nothing can go wrong with the gear box unless you changed the hole diff assy.

Oct 05, 2014 | Cars & Trucks

1 Answer

94 ford ranger manual transmission goes into first gear and reverse just fine let off the clutch and the truck wont move.


part of a clutch job is removing the gearlever make sure the lever is secured properly and selects the gear correctly.
Orherwise your symptoms sound like a collapsed pressure plate or broken release bearing either defective part or something done wrong during installation of clutch

Apr 13, 2017 | Cars & Trucks

1 Answer

My 2001 Chevy 2500 HD 6.6 L turbo diesel won't


fuel injection pump is failin or has issues--getta haynes manual for pro car maintenance

May 30, 2012 | 2001 Chevrolet Silverado 2500HD

1 Answer

I have a 94 chevy 2500 that is stuck in 3rd gear, or wont shift correctly, shop says its an "ignition switch"


My truck had this issue, or one very similar. The 4L80E transmissions have a defect where transmission fluid can leak up into the big round electrical plug and short everything out. There are YouTube videos on how to clean out the plug and seal it so it doesn't happen again.

Mar 09, 2017 | Cars & Trucks

1 Answer

I have a 94 f350 turbo diesel. and it has big oil leak on the back of the engine. i just replaced the rear main. and only leaks wen running.wat could it be.


If you have replaced the rear main bearing,You may have damaged the rear crankshaft seal.Check to see if its comming from where the engine meets the gearbox.

Jun 15, 2011 | 1994 Ford F350 Crew Cab

1 Answer

I hav a 94 chevy k1500 but it wont stay running. One morning i started it up, got it warm then while i was goin down the road it acted like it was running out of gas,would die then start back up then just...


Turn on the key and listen by the fuel tank for the fuel pump to hum. A common problem is low fuel pressure. It will build pressure when the key is turned, use that fuel, and then the pressure drops. Kind of like when you're using a squirt gun that's getting empty.

Feb 28, 2010 | 1994 Chevrolet K1500

1 Answer

Turbo sticking


If you are sure it is sticking then it must be changed. Repairs to turbos need to be done with extreme precision that are beyond the scope of the home DIYer. Hope this helps.

Jan 10, 2010 | 1994 Chevrolet C1500

3 Answers

Ford probe


the front drive axle on one side may have not been installed all the way in to the transmission, check to see if it is loose and have some one look under front end with engine on, front end jacked up, emergency brake on and in gear to see if a axle is turning. if one is and yhe other is not put the car in park and turn\ roll the wheel that was not turning by hand if it rolls your problem is most likley to be the axle has come loose from the transmission

Oct 18, 2008 | 1990 Ford Probe

1 Answer

Chevy truck


74 Traction control circuit voltage low

Jul 24, 2008 | 1994 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

397 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Ryan Lutton
Ryan Lutton

Level 3 Expert

1256 Answers

john h

Level 3 Expert

23515 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...