Question about Infiniti Cars & Trucks

Open Question

J30 P1443 code

Canister control vacuum check switch location

Posted by Anonymous on

Ad

5 Related Answers

Paul Hutchinson

  • 909 Answers

SOURCE: Codes p0402 and p1443 96 ranger

this means exactly what it says, the emission control valve is faulty and needs replacing.
Basically the valve is in an open position when it should be shut or partially shut.
Replace the valve and this should cure both codes.

Posted on May 07, 2009

Ad

Anonymous

  • 34 Answers

SOURCE: code was P1443. I put

you need to have the computer reset to get the check engine light to shut off there is a list of error codes that has to be cleared from the computer so the check engin light will shut off but it wont hurt to drive with the light on for a while as long as you fixed the problem

Posted on Jun 06, 2009

Ad

Anonymous

  • 1 Answer

SOURCE: 2000 Honda Odyssey Fuel Vapour Canister location

It is located at the top of the gas tank. You are going to have to drop the tank in order to check it, so it is best to do this when there is not a lot of gas in the tank. Hope this helps you out.

Posted on Aug 21, 2009

scott

  • 532 Answers

SOURCE: I need to locate the canister purge valve and the

look above the spare tire under the back of the box

Posted on Oct 24, 2009

motor1258

Mike Butler

  • 6674 Answers

SOURCE: emission test showed error code p1443.check engine

You might want to try "google images" just type in your vehicle and what your looking for. Here's an example (link) of what to look for.

http://www.fordmuscle.com/forums/attachments/all-ford-techboard/4132d1212515121-code-p1443-help-96tbird_evap.jpg

Posted on Oct 25, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Check enging is on---OBD code is PO171 & p1443---how do i fixed this problem


The most likely cause of these two codes tripping together is a vacuum leak associated with the canister purge system. This system collects the vented gasoline vapor from the fuel tank and when the engine is running purges the canister into the manifold.

The P0171 is an indication that the engine is running lean and the P1443 is a fault associated with the Purge Control Valve Solenoid trouble code control valve.

Inspect under the hood for a disconnect vacuum line.

The photos are examples of the vacuum circuit connect via hoses. Listen for a vacuum leak when the engine is running. It would be a whistle sound. Also if work has been done recently look in the area that the work was done under the hood.

26150454-uk2ysmhepcorsq0r4fy0hyob-4-0.jpg

26150454-uk2ysmhepcorsq0r4fy0hyob-4-2.jpg Hope this helps?

Apr 03, 2016 | Cars & Trucks

1 Answer

What is code p1443 on 96 thunderbird


PCV valve would have nothing to do with it !
P1443 - Very Small Or No Purge Flow Condition A fuel tank pressure change greater than a minus (-) 7 inches of H 2 O in 30 seconds has occurred with purge (fuel vapor) flow less than 0.02 pounds per minute.
  • Blocked fuel vapor hose between EVAP canister purge valve and FTP sensor.
  • Blocked fuel vapor hose between EVAP canister purge valve and engine intake manifold.
  • Blocked vacuum hose between EVAP canister purge valve-solenoid and engine intake manifold.
  • EVAP canister purge valve stuck closed (mechanically).
Check for blockages between the fuel tank, EVAP canister purge valve and engine intake manifold. Check obstructions in the EVAP canister purge valve diaphragm and ports.
Suggest you buy a repair manual if you want to try an fix yourself .Or Go to ford web site Ford Oem1stop com an pay 29 bucks for 72 hours for repair info . Or take it to a qualified repair shop an have it smoke tested . Or goolge purge valve for a pic. an see if you can find it under the hood .

Feb 20, 2018 | 1997 Ford Thunderbird LX

2 Answers

Check engine lite came on code is p1443 what does this code mean


P1443 Evaporative Emission Control System Control Valve The Evaporative Emission Control System monitors the fuel vapor flow between the engine intake manifold and the EVAP canister. The system failure occurs when a leak or blockage between the intake manifold, the EVAP canister purge valve and the EVAP canister is detected by the PCM.

Code P1443 Possible Causes:

- Pinched, blocked or plugged fuel vapor tubes/hoses (except between fuel tank and EVAP canister)

- Damaged EVAP canister

- Disconnected, cracked or cut fuel vapor tubes/hoses (except between fuel tank and EVAP canister)

- Damaged EVAP canister purge valve

May 04, 2011 | 1997 Ford Escort

1 Answer

P1443 code How do I fix this code problem on my 97 Ford ranger?


P1443 is the Evaporative Emission Control System Control Valve. Any time you get this code always check your gas cap. If it is not installed all the way, or leaks, it can cause the evap emission code to come up. If the cap is okay...

The problem is probably caused by the Canister Purge Assembly. This assembly connects the intake manifold to the charcoal canister and the assembly is made up of hoses, a valve and a sensor. On the 1997 Ranger, it is located near the front of the engine compartment on the driver's side (the canister is right behind the driver's side headlight). Apparently, if there are any cracks in the hoses, or if the valve or the sensor wears out, this will cause the check engine light to come on, and return the P1443 code.

Part numbers for the canister purge solenoid/flow sensor assemblies:

F57Z-9C987-AB Canister Purge Solenoid/Flow Sensor
Assembly - 2.3L F57Z-9C987-CA Canister Purge Solenoid/Flow Sensor
Assembly - 3.0L F57Z-9C87-BA Canister Purge Solenoid/Flow Sensor
Assembly - 4.0L

Part cost = $65 to $100 depending on engine size - good luck :O)

Feb 17, 2011 | Ford Ranger Cars & Trucks

2 Answers

Ford escort wagon 1997 code p1443 displayed. what does this indicate & where is the cannister? thank you.


P1443 - EVAP Control System / Vacuum System Purge Control Solenoid Or Purge Control Valve Fault. A fuel tank pressure change greater than minus (-) 7 inches of water in 30 seconds occurred with a purge (fuel vapor) flow at less than 0.02 pounds per minute.

Possible Causes:
  • Blocked fuel vapor hose between the EVAP canister purge valve and the FTP sensor.
  • Blocked fuel vapor hose between the EVAP canister purge valve and the engine intake manifold.
  • Blocked vacuum hose between the EVAP canister purge valve solenoid and the engine intake manifold.
  • EVAP canister purge valve stuck closed (mechanically).

  • Possible Solution:
    Check for blockages between the fuel tank, the EVAP canister purge valve, and the engine intake manifold. Check for obstructions in the EVAP canister purge valve diaphragm and ports.

    The canister is on the passengers side near the firewall if I recall correctly.

    Jan 18, 2011 | Ford Escort Cars & Trucks

    1 Answer

    2004 niisan infinty g35x code p2135


    NISSAN OBDII DTC

    P1105 Manifold Absolute Pressure/Barometric Pressure Switch Solenoid Circuit

    P1110 Intake Valve Timing Control Circuit (Bank 1)

    P1120 Secondary Throttle Position Sensor Circuit

    P1125 Tandem Throttle Position Sensor Circuit

    P1132 Intake Valve Timing Control Position Sensor (Bank 1)

    P1135 Intake Valve Timing Control Circuit (Bank 2)

    P1137 Intake Valve Timing Control Position Sensor (Bank 2)

    P1140 Intake Valve Timing Control Position Sensor (Bank 1)

    P1145 Intake Valve Timing Control Position Sensor (Bank 2)

    P1148 Closed Loop Fault Detected (Bank 1)

    P1168 Closed Loop Fault Detected (Bank 2)

    P1210 Traction Control System Signal Fault

    P1220 Fuel Pump Control Module Fault

    P1320 Ignition Control Signal Fault

    P1335 Crankshaft Position Sensor Circuit

    P1336 Crankshaft Position Sensor circuit

    P1400 EGR/EVAP Control Solenoid Circuit

    P1401 EGR Temperature Sensor Circuit

    P1402 EGR System Fault Detected

    P1440 EVAP Canister System Leak Detected

    P1441 EVAP Vacuum Cut Valve Bypass Valve Circuit

    P1443 EVAP Canister Control Vacuum Switch Circuit

    P1444 EVAP Canister Purge Volume Control Valve Circuit

    P1445 EVAP Purge Volume Control Valve

    P1446 EVAP Canister Vent Valve Circuit

    P1447 EVAP Canister Purge Flow/Volume Control Valve Circuit

    P1448 EVAP Vent Control Valve Circuit

    P1490 EVAP Vent Control Valve/Bypass Valve Circuit

    P1491 EVAP Vacuum Cut Valve/Bypass Valve Circuit

    P1492 EVAP Canister Purge Control Valve/Solenoid Valve

    P1605 Transmission Control Module A/T Diagnosis Communication Line Fault

    P1705 Throttle Position Switch Circuit

    P1706 Park Neutral Position Switch Circuit

    P1760 Overrun Clutch Solenoid Valve Circuit
    P1900 Cooling Fan Control Circuit
    sorry but your code reader is not reading manufacturers codes ,if an american market vehicle then you should be able to read them but if this is a europeon model then how did you manage to get this code??

    P0235....Turbo/Super Charger Boost Sensor 'A' Circuit

    this is a generic code if its any help

    Nov 02, 2010 | 2004 Infiniti G35 Sport Coupe

    1 Answer

    What is check engine code p1443 on a MAZDA 1996 B2300 TRUCK


    Diagnostic Trouble Code (DTC) P1443 indicates a failure in the EVAP canister purge valve circuit. The Evaporative Emissions (EVAP) Canister Purge (CP) valve controls the flow of vapors from the fuel vapor storage canister to the intake manifold during various engine operating modes. It may need nothing more than a good cleaning, vacuum hose connected or that is leaking, or may need more. I suggest you seek out the services of a good mechanic. Do not just throw parts at this. The code does not mean that any part needs replacing. It just means the EVAP system is being effected.

    Apr 21, 2010 | Mazda B2300 Cars & Trucks

    2 Answers

    1996 Ranger-code P1443-"auxillary emmisions controls" is the decription that I got from Advance Auto Parts diagnostic--What can the problem be?


    the Canister Purge Assembly. This assembly connects the intake manifold to the charcoal canister and the assembly is made up of hoses, a valve and a sensor. it is located near the front of the engine compartment on the driver’s side (the canister is right behind the driver’s side headlight). Apparently, if there are any cracks in the hoses, or if the valve or the sensor wears out, this will cause the check engine light to come on, and return the P1443 code.

    Oct 05, 2009 | 1997 Ford Ranger SuperCab

    1 Answer

    Check engine light 97 mercury tracer code p1443


    9 times out of 10, your gas cap isn't tightened properly. Check the PCV valve and connecting hose for damage or crimps. Look for broken or disconnected vacuum lines coming from the canister (located under the air cleanner). If they're all good, check the "canister purge solenoid" (passenger side firewall). You will need to reset the code after you make any repair to turn off the check engine light.

    Jun 11, 2009 | 2001 Lincoln Continental

    Not finding what you are looking for?

    Open Questions:

    Cars & Trucks Logo

    Related Topics:

    66 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Infiniti Experts

    Marvin
    Marvin

    Level 3 Expert

    85239 Answers

    Thomas Perkins
    Thomas Perkins

    Level 3 Expert

    14852 Answers

    Arnie Burke
    Arnie Burke

    Level 3 Expert

    6528 Answers

    Are you an Infiniti Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...