At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Start signal comes from the clutch engagement switch. When you press the clutch the pedal arm hits a switch and signals the motor to be able to start. Look and see if you have a little rubber piece pushed through a hole on the clutch pedal arm
the throttle position is bolted on to your throttle body, you should check your air flow meter also, the ecu, located behind the passenger kick panel, has a self diognastic mode with all the code definitions listed on the ecu, if i remember correctly turn the key on , dont let starter engage, pusk gas pedal to floor, release, then the ecu will bling red and green, two red blinks and one green means code 21 and so on
The self-diagnostic system identifies malfunctions of signal systems such as sensors, actuators and wire harnesses based on the input signals received by the ECCS control unit. Various malfunctions are coded and displayed on the control unit by a series of blinking red and green lights. Results of the self-diagnosis are retained in the control unit's memory and are displayed when the mode selector, located on the rear of the control unit, Fig. 122, is switched to the On position. When displaying malfunction codes, the code number can be determined by counting the number of light pulses. The red light represents the first digit of the code, while the green light represents the second digit of the code. For example, a Code 32, would be displayed as three flashes of the red light, followed by two flashes of the green light. Malfunction codes can be translated as follows:
Don't get too concerned yet. Take it to the shop and let them scew in a well know mechanic's gage to make sure that the sensor isn't giving you a bad signal. That would be the first place to check.
×