You will find some simple instructions here, about how to do it manualy.
How to reset oil manualy : Cummins Signature ISX and QSX15 Factory Manual Repair Servic Download...
Unplug battery for 24 hours
If you need further help, I’m available over the phone at https://www.6ya.com/expert/richard_b59056c0c62ecb00
SOURCE: 2008 Scion TC Warning Light
This is already covered in the owner's manual, but here it is again as a quick reference.
Every 5,000 miles, a "Maintenance Required" light will blink for the
first couple seconds after you start your car. It will continue to do
so until it is reset. If it is not reset, than it will eventually turn
on your "Check Engine" light. The purpose of the maintenance required
light is to remind TC owners to change their oil. The factory
recommended interval is 5,000 miles, but you can reduce the interval
the light will come on to a mileage interval of your choice.
1. Before starting, make sure that the odometer is not on one of the
trip mileage odometers but is displaying the standard odometer.
2. With the car off, press and hold down the odometer reset button. While still holding it, start the car.
3. The light should continue to blink for a couple seconds and than
disappear. That will reset the light for another 5,000 miles.
4. The following are steps to change the interval in which the
maintenance required light comes on. Right after you turn on the
ignition while holding the reset button, you'll notice that the
odometer display will show 5 bars. Each bar corresponds to a 1,000
miles. As each bar disappears, the interval will increase (0 bars = 5k,
1 bar = 4k). Release the reset button at the interval you desire.
SOURCE: How do I get the "Change Oil " light to go off after change .
Turn key to the run posistion and pump the gas peadle 3 times under 5 seconds.
SOURCE: How do I reset the oil change light in a 2008 Chevy Suburban
Try this: turn the key to the RUN position (don't start it), press the
accelerator to the floor 3 times within 5 seconds. The oil life light
should flash twice, indicating that it's been reset.
If you have
steering wheel controls, you can navigate to where it says Oil Life and
then hold the arrow down, that should also reset the oil life.
SOURCE: 1999 audi a4 oil reset light
Turn off the ignition press and hold the button on the leftside of the display while turning the ignition on it should say service oil on the display pull out the button on the rightside of the display until the service oil clears
SOURCE: Perform Service light reset
1.Turn key on/eng off
2.Press brake pedal slowly 2 times
3.Press gas pedal 2 times within 10secs.
4.Turn key off
3,089 views
Usually answered in minutes!
×