2007 BMW 530xi Sports Wagon Logo

Related Topics:

A
Anonymous Posted on Dec 19, 2013

I have 2007 252i bmw my brake fluid trun on so i bought brake fluid and fill with brake fluid it in level now . but it is still lighting the sensor on.

5 Related Answers

Anonymous

  • 98 Answers
  • Posted on Dec 11, 2008

SOURCE: bmw brake sensor

if your talking about the switch that tells when your foot is pressing in the break yea just get under there and there should be a button switch with a nut you back off then remove the switch out of the brace.

Ad

Anonymous

  • 7 Answers
  • Posted on Apr 14, 2009

SOURCE: HOW DO YOU CHECK THE TRANSMISSION FLUID LEVEL ON A

in park idling

Anonymous

  • 318 Answers
  • Posted on Jun 07, 2009

SOURCE: Yellow DSC and Brake light on... recently changed brake pads

Abs and dsc are related and with the light on these won't work. It is possible that you need to go back to where the work was done to look this over.

Anonymous

  • 2702 Answers
  • Posted on Oct 22, 2009

SOURCE: 2004 BMW ci with 58K miles Car leaks reddish

oh dear, this is going to be very bad new for you,take it from me the ATM fluid is leaking out of your gearbox, it could be a rear gearbox oil seal, it could be the front gear box oil seal leaking, even the oil cooler or pipes leaking but it is leaking some were, and if its got to be took out to put in a new seal your going to need to sell a kidney or some outher part of you to pay for it, if you can put up with the leak just keep filling up your ATF fluid dont let the gearbox run dry or its realy going to cost you, as it will seize up on you and burn its self out, thats a new gear box then??? costly very costly! if its only a little bit of oil leaking give the motor a good wash down with a power hose under it and fill the atf up go for a drive say 10 miles then look under it, look for fresh oil (ie:red oil) around the gearbox at both ends of it, if you see any that is proof its leaking bad!!! park it over a sheet of paper over night will show how much it leaks too, i would put up with it as long as pos bet if its due for an MOT give it a realy good power wash down first to get rid of any oil, a little leak will still pass, a big un, wont! any oil seal can just fail on you like this one has but they fail much faster if they get over heated due to lack of oil in them
sorry for the bad news, think of selling the kids to pay for a new gearbox,, now there's an idear?

steve_e_uk

steve morris

  • 1675 Answers
  • Posted on Mar 21, 2010

SOURCE: where is the brake fluid fill cap on a 2006 bmw

hi this is normally located to the drivers side bulk head on the servo unit under the hood/bonnet

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Abs brake warning light, bmw x5 2004

i would guess the brake warning light is the sensor telling you your pads are low. check the brake fluid and see what level it is, no need to add oil unless it is almost empty but then you would be hearing a squeek grinding noise from brakes. those only cost a few (i think $5) to replace when you do your brakes. but this is just a guess please make sure you have breaks before driving
0helpful
1answer

My brake light is on what should I do

Make sure you're getting the emergency brake fully disengaged to see if it goes off.
Also.
Check the fluid level in the brake fluid reservoir. If it's low, top it off and get it to a mechanic asap.
If the fluid checks out ok, your brake pads may be triggering a sensor if they need replacing.
0helpful
1answer

Cant reset the brake worning light

check the brake fluid level if its low the warning light stays on top it up
2helpful
1answer

BMW 318 ci coolant light comes on then goes off -

more than likely is being caused by a faulty level sensor but first check the connection and fluid level when engine is cold as fluid level will rise when engine warms up
Mar 28, 2010 • 2003 BMW Z4
0helpful
1answer

Brake warning light is on, emergency brake is ok. Is brake cylinder at back of engine on driver side? Do I just add brake fluid to the fill line? Is there a particular kind of brake fluid to use?

If the fluid is lower use dot3 brake fluid.There is a sensor in the master cylinder for the level.If the light goes off then have your brakes checked out if your pads are low the the calipers will be moved out when this happens the fluid level will drop if the calipers are push back in after brake pads are installed the fluid level will go back up i hopes this helps :)
5helpful
1answer

97 Altima dashboard brake light stays on

Check your brake fluid level in the engine compartment. Its located on the rear RH side of the engine compartment, its a white/clear resevoir connecting to a large black circular object. If the fluid is low, fill to proper level, also I would recommend having your brake system checked as there may be a leak. If the fluid is fine and at the proper level, you may have a damaged/broken brake fluid level sensor or damaged/broken Emergency brake switch. Hopefully this helps....please rate thanks!!
0helpful
2answers

Brake light on the dash has just come on

If your brake fluid is down it will cause the brake light to come on. If you fill the brake reservior, the light should go out. If it does then you should have the brakes checked for wear. As the brakes wear the fluid follows behind to fill the gap, thus low fluid. Let me know if this helped. Moe
2helpful
1answer

Where do u put transmission fluid in a bmw 740il 2001

Here is the procedure:

The transmission temperature must be between 86° to 130° F (30° to 55° C) before checking With engine running, switch on AC While holding vehicle with brakes, place transmission into each gear briefly With engine running and transmission in park, remove Fill/Check plug. If a small amount of oil runs out, fluid level is correct. If no oil runs out fluid level is low, add fluid as required through Fill/Check plug hole. When level is correct, reinstall Fill/Check plug and tighten to correct torque.
0helpful
1answer

Hi,ive got the abs,traction control and handbrake light lit on my dash.the lights are on constant.can you help.

Hi, the lights get lit when the brake fluid level in the reservoir falls too low or the fluid level signal is broken due to dirt in the connector. You could remove and install the sensor electric connector, located above the reservoir, and carefully knock the reservoir to release the possibly stuck level sensor.
Not finding what you are looking for?

50 views

Ask a Question

Usually answered in minutes!

Top BMW Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

old marine
old marine

Level 3 Expert

2426 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...