Question about 1993 Ford Taurus

1 Answer

Heater does not work on 1999 ford taurus

I have flushed radiator and heater core then changed the resistor. Thermostat has also been changed. Blend door is working what else can it be.

Posted by Michael Hambric on

Ad

1 Answer

Cecil Stevens

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 74 Answers

Heater motor? and/or no heat inside of car?...

Posted on Dec 18, 2013

Ad

2 Related Answers

Anonymous

  • 82 Answers

SOURCE: 1999 ford taurus no heat

Is the blower motor working? If not that is what it is. If it is working then check heater coil out, Could be bad heater coil.

Posted on Nov 10, 2009

Ad

Anonymous

  • 23 Answers

SOURCE: 1998 ford taurus no heat,replaced

You might have to purge the coolent system cause when you change stuff like that you normally have to bleed the the colent system. So what you have to do is run the car untill your temp gets to 195 degrees the cut the car off and let the coolent drain down and then refill and geep doing that untill you have heat.

Posted on Jan 09, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

My heater stoped working the a\c still works and fuses are fine


Either the heater core is clogged or busted, or a blend door is broken.
YOU TUBE has a lot of videos on this subject.

Jan 28, 2016 | 1998 Ford Expedition

1 Answer

Heater blowing cold


if u flushed heater core n both hoses to heater are hot, then more than likely the blender door is not allowing heat to enter the inside of car...a lotta times itz located behind glove box where u can chek it...dependz on the car...

Dec 18, 2013 | 1999 Ford Taurus

1 Answer

I have a 2002 ford taurus and the heater isnt working all that well and i was wondering what things i should check


The heater core is under the dash.
If the engine is reaching normal temp, and both heater hoses are hot, you may have a problem with a blend door under the dash.

Feb 04, 2013 | 2002 Ford Taurus

2 Answers

I have no Heat in my 2000 Ford Taurus!


If the heater core bypass refers to the water flow to the heater core, I would wonder why you did not flush the heater core as part of the system. You can drain water from engine, disconnect heater hoses and add a short hose to the heater and force a garden hose to flush the core.

I have not looked up the particulars for which heater system is on your car. Some just use duct-work to close off air flow through the heater core and the heater core always has hot water in it. Others will use a valve to shut off the water flow through the heater core and they can be either electric or vacuum operated. Combination systems are the third system which controls water flow and duct air flow at the same time.

Some of the Premium Climate control systems with Electronic displays have a computer diagnostic system which self-diagnoses problems but you need the sequence codes and explanation of where the bad part is located.

Aug 08, 2017 | 2000 Ford Taurus

1 Answer

My 1999 ford taurus heater doesnt work. We recently had a problem with the reservoir boiling over and brown coolant. Had the thermostat replaced and replaced the radiator cap. Also flushed the radiator....


Sounds like the heater core may be blocked..First check the level make sure its full..Then let the vehicle get up to operating temperature..Feel the heater hoses going into the firewall..Both should be hot to touch..If one is hot and the other one is warm or not warm ,,then you have a blockage in the heater core..If its block ,,then i have cleaned them out by taking the heater hoses off,,and running a garden hose through the heater core..If that doesnt work then you have to remove the dash,,and replace the heater core..

Sep 24, 2011 | 1999 Ford Taurus

1 Answer

1998 ford taurus no heat,replaced thermostat,heater core and the blend door motor seems to be working, flushed radiator, and still no heat, any suggestions?


You might have to purge the coolent system cause when you change stuff like that you normally have to bleed the the colent system. So what you have to do is run the car untill your temp gets to 195 degrees the cut the car off and let the coolent drain down and then refill and geep doing that untill you have heat.

Jan 09, 2010 | 1998 Ford Taurus

1 Answer

Change radiater and heater radiater i dont have taurus 98


Have your heater core flushed. Works like a charm every winter when I do it.

Dec 11, 2009 | 1999 Ford Taurus

3 Answers

1999 ford taurus no heat change thermostat checked hoses flushed heater core and radiator


Is the blower motor working? If not that is what it is. If it is working then check heater coil out, Could be bad heater coil.

Nov 10, 2009 | 1996 Ford Taurus

Not finding what you are looking for?
1993 Ford Taurus Logo

262 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...