Fuse diagram proton savvy

SOURCE:

Not familiar with this car, but first you have to find the power wire to the switch-that will be one end of your jumper wire. Use a test light clipped to ground, turn key to on, and probe all the wire cavities till you find the hot wire to switch. Now pull out on the electrical connector and see if you can see the two wires going down to driver's door motor. Then see where they connect to the connector. When you touch the jumper wire end to one, it will be for either up or down, and the other motor wire when connected to hot jumper wire will be the opposite, either down or up.
If window is all the way up, jumping hot to up side will make no noise, and cause nothing. So you try the other motor wire to see if motor makes window go down. See, you have to jump hot wire to both to verify the motor works or not.