Where is ambient air sensor located on a 2002 jeep tj wrangler

SOURCE: 2004 Jeep Wrangler TJ won't

if your jeep has a harder time starting when its warm as well, i would say the throttle position sensor is bad, or dirty. mine does tah same thing. i just live with it. its cheaper than replacing it.

Posted on Aug 12, 2008

SOURCE: how to replace a jeep tj fuel tank?

I would be really careful with doing this repair as this is very dangerous. You need to relieve the fuel pressure by pulling the fuel pump fuse and starting the truck. Drain the tank with a siphon pump. Remove any exhaust or other parts that are in the way, loosen the straps and support the tank with a floor jack and a block of wood. There are several hoses, and a few wire connectors to disconnect and you may want to replace those hoses while you're down there. Once you put the new tank in, reconnect the electrical and hoses, raise the tank and strap it back up. Put anything else back together you took off the truck.
Personally, I would take this in to get fixed as this is dangerous work (I did mention that). I you do this anyway, use your head and buy a proper container to hold the gas in , as well as jackstands and a class "B" fire extinguisher. Disconnect the battery and don't smoke or use a drop light under the car, and I will not accept responsibility for this.

Posted on Dec 26, 2008

SOURCE: locate the cabin air filter for a 97 jeep wrangler

No cabin filter in a 97 Jeep Wrangler.

Posted on Apr 15, 2009

SOURCE: jeep wrangelr Crank Position Sensor

wall5552: there were two engines used in 1992 Jeep Wranglers.
A 2.5 liter and a 4.0 liter. HOWEVER>>>> The location for the crank angle sensor is the same for both.
It is located on the bell housing up near the front at about the 10:00 PM position.
The Cam position sensor is located in the Distributor on both engines as well.

Posted on May 10, 2009

SOURCE: Ambient temp sensor replacement

The ambient air temp sensor is located on the radiator support bracket at the top (see figure below, item 1)

Posted on Jul 14, 2012

Testimonial: "Thank you for assisting me. "