At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Make sure you replace it after removal. It is part of the safety system and prevents you getting a broken neck in a crash.
Depress the large button on the head restraint guide and raise the head restraint to the full up position. Depress the smaller button on the opposite head restraint guide and pull upward to remove from the seat.Jan 16, 2022
Remove the headrests. Then slide the cover over the seat back cushion (Photo 5). Push the bottom straps through the gap and into the buckles just like you did on the bottom cushion (refer to Photo 3). Reconnect the bib panel and pull down on the rear portion of the seat back cover to remove wrinkles.
Tilt the seat then you will see two plastic surrounds where the headrest supports slide into, one will have a tab, with the seat tilted so the headrest can clear the roof push the tab at the same time as you tug the headrest out and the headrest will slide out.
There is a button you need to press at the bottom of one of the headrest rods (it is actually part of the main seat), but it is located right where the rods of the headrest enter.
Neither of the answers are actually correct.
Yes you need to press the button PLUS use a number drill or similar in the little hole on the opposite headrest leg @ the same time. The headrest will come out very easily when you do bothe these things @ the same time.
There is a Pin hole on one side of the headrest in the plastic base. You have someone put a small Allen wrench in the hole till it presses against the metal spring and also on the release on the other side, then pull the headrest out. You will have to press on the spring to put the head rest back in also.
hello,you need to remove your rear seat,,look for your your headrest valve ,there is a lock pin with tension clip in headrest rod ,remove the pin,try to remove your headrest slowly,ty
There is a plastic cover, about 1 1/8" diameter, on the base of the post on each side. You can remove it with a screw driver by carefully prising upwards at the edge. They just clip down.
Once these are lifted away from the seat, you will see the wire clip that locks the headrest into the seat. Remove the clip on each post, and you can then remove the headrest.
Reassembly is the reverse.
The headrest has on obvious button to adjust the height and another button kinda hidden to remove the headrest. The black plastic ring at the base where the metal poles insert into the seat is where the two buttons. You probably noticed the obvious on that sticks out of the side of one of the rings. The other plastic ring contains a similar button that is not noticeable due to it being flush with the side of the plastic ring. Adjust the headrest to its highest position, then locate the "hidden" button on the other plastic ring and depress it while lifting on the headrest and it should come out.
×