All instrument panel lights or just speedometer light? There are several bulbs behind instrument panel. More than likely, the bulb at speedometer is burned out, and can be replaced by removing instrument panel and replacing bulb(s). Hope this helps.
SOURCE: 1989 Cadillac Eldorado dies right after I start it
you could see if you have a friend that could help you bye starting the car for you and you need to un hook the top of air box as if you were going to change the breather take a small coke bottle and pour about 1 cup of gas in your bottle hold your breather hose up and pour about 1/2 shot glass gas down the hose and see if that alows it to continue to run if it does you may have a bad or weak fuel pump but I will warn you to be careful when dealing with gasoline do not go to overboard use your best judgement
SOURCE: how do you remove a 1989 cadillac eldorado
LOL well jack the vehicle up!! support on stands and remove both axles and the flywheel bolts and dust cover in the front under that trannys remove fluid lines from tranny and shift linkage also remove all 6 bolts from tranny to engine and slide back and down
SOURCE: what should the fuel pressure
Welcome to FIxYa.com
FUEL PRESSURE: Ignition ON Engine OFF . 315 to 43.5 psi With Regulator Vacuum Applied Il] 3.0- 10.0 psi Less than
Ignition ON Engine OFF RflL4RKS: II] May be checked with either of the following methods. With Pressure Regulator Vacuum Line Attached at normal idle
speed : Ignition ON Engine OFF with 10 Inches Of Vacuum Applied To
The Pressure Regulator. Thank you for using FixYa.com Regards, Lee Davidian
SOURCE: 1992 CADILLAC ALLANTE ...THE SPEEDOMETER CLUSTER
I removed the Digiital Cluster and found out the there is a High Voltage design that powers a bulb appox 4" x .6" that provides the back illumination, I'm attempting to find out what type bulb it is and to see if can be subsituted for and LED design. I'm in the LED business, and trying to get the Lumms and the current figured out.
[email protected]
SOURCE: My speedometer has stopped working
Take off the cable connection on the back of the speedo. Maybe hard to get at . Or, remove the bottom end on the gearbox. You should be able to pull out the inner cable to get a look at it. Quite simple to fit a new one, just slide it in.
194 views
Usually answered in minutes!
×