1999 Lincoln Town Car Logo

Related Topics:

Anonymous Posted on May 01, 2009

Wiper motor replacement

How do i replace the wiper motor on a 99 lincoln town car

1 Answer

gerry bissi

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Lincoln Master 4,390 Answers
  • Posted on May 14, 2009
gerry bissi
Lincoln Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jan 07, 2009
Answers
4390
Questions
1
Helped
3059234
Points
11499

SECTION 501-16: Wipers and Washers 1999 Town Car Workshop Manual REMOVAL AND INSTALLATION Mounting Arm and Pivot Shaft Removal

  1. Disconnect the battery ground cable (14301).
  1. Remove the windshield wiper pivot arms (17527).
    1. Remove the nuts (one each side).
    1. Remove the windshield wiper pivot arms.
  1. Remove the LH and RH cowl top vent panels.
    1. Remove the hood weatherstrip.
    1. Remove the screws.
    1. Remove the retaining clips.
      • Disconnect the LH and RH washer hoses.
  1. Position the windshield wiper mounting arm and pivot shaft (17566) assembly aside.
    1. Remove the nuts.
    1. Remove the bolt.
    1. Position the windshield wiper mounting arm and pivot shaft assembly aside.
  1. Remove the windshield wiper mounting arm and pivot shaft assembly.
    1. Disconnect the electrical connector.
    1. Remove the windshield wiper mounting arm and pivot shaft assembly.
----------------------------------------------------------------------------------------
Motor —Windshield Wiper Removal
  1. Remove the windshield wiper mounting arm and pivot shaft (17566) assembly; refer to Mounting Arm and Pivot Shaft .
  1. Remove the windshield wiper motor (17508).
    1. Remove the output shaft bolt.
    1. Remove the bolts.
    1. Remove the windshield wiper motor.

5 Related Answers

Anonymous

  • 319 Answers
  • Posted on Mar 19, 2009

SOURCE: lincoln town car will not start

check the emergency safety switch for the fuel pump. should be located on the L side of the trunk side panel

Ad

Anonymous

  • 1623 Answers
  • Posted on May 13, 2009

SOURCE: heat wont work 2001 lincoln town car cartia

Hello Callahan5922....this sounds like a stuck blower motor resistor. I assume the blower won't function in the a/c mode either? If you have a digital multimeter you can check this. I believe it's fuse #2....if the digital indicator goes up or down when you increase or decrease the fan speed thats good. Locate the blower motor resistor....you wil find it located on the fire wall behind the right valve cover hiding behind the heater hose, it's about the size of a cigarette pack. With the engine off, and key in on position, turn the A/C on High, and rap a tap tap tap on the resistor. You might be suprised when the blower motor takes off a runnin,
I hope this is the answer you need and i was able to help solve this for you. Good luck...

Anonymous

  • 5 Answers
  • Posted on Aug 19, 2009

SOURCE: 1997 lincoln town car 4.6 with a p0430 fault code

I will make an assumption here, we know what the root word means. This code was extracted from the computer by? What this is telling you one of 2 things: The Bank 2 oxygen sensor down stream of the catalytic converter (there are 2 converters, one for each bank of cylinders on the 4.6ltr engine) is bad and/or that the Bank 2 catalytic converter is no longer doing the job it was designed to do. Simply, Catalysts wear out. They are good for approx 100,000 miles (as required by Federal Law). Again, I assume that the reason the intake manifold was replaced was because it had a crack in one, or more, of the runners? (part that feeds the head of a manifold). It may have taken a while to find this as being the cause of why the car running incorrectly, maybe rough. This means, that during the time the car was being driven with the problem, the amount of unburned, or not within spec exhaust gases, coming off the side of the engine affected by the intake issue was higher than normal. This out of balance level of exhaust gases were being dumped into the converter on that side of the engine, thus causing the converter to have to run hotter, work harder, or even at the time the gas was being processed through, causing deposits to be formed in the converter, thus shortening it's life span. The Bank 1 side of the engine, apparently, did not have the issue and it's catalytic converter's life was not affected. I hope this makes sense to you.

co7196

Ned C Cook

  • 3433 Answers
  • Posted on Oct 06, 2009

SOURCE: 2002 Lincoln Town Car AC Blower Motor Relay Location

Relays are normally located under the hood in a protective plastic box. Good Luck Ned

Anonymous

  • 1865 Answers
  • Posted on Oct 15, 2009

SOURCE: 1995 Lincoln town car blower motor resistor

I believe you have to replace the switch assembly.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Does a 99 lincoln have a knock sensor?

On both cars the knock sensor is located in the intake valley.
a0028125.gif
the computer receive signals if engine knocking and adjust the timing till stop.Before replace the sensors make sure the engine have no other misfire ,bad gas or vacuum leak.plug scan tool and read the code.Only circuit problem will be a true knock problem. Inspect all wire connectors before start taking a part.
0helpful
1answer

Wiper control module location

the wipers are controlled by the lighting control module
0helpful
1answer

99 towncar replaced windshield then wipers stopped working.replaced motor.few days ago car key would not come out after placing in park and turning it off had to do this several time to get key to come...

Sounds like a possible ignition switch or ignition actuator problem to me. I would recommend getting it checked by a professional so you do not end up replacing MORE parts that do not fix the problem.
0helpful
1answer

The winshield wipers stay strait up when turned off on a 94 lincoln town car

The park mechanism inside the wiper motor has malfunctioned. you will need to replace the wiper motor to get the wipers to stop where they're supposed to.
0helpful
1answer

How to replace wiper motor 2000 lincoln town car??

location of wiper motor 2000 linclon towncar
1helpful
1answer

Fuse for windshield wiper motor

It may be the windshield wiper module instead of being the motor, since you have had that replaced 3x already. There should be no fuse issue.
0helpful
1answer

95 Lincoln town car--intermittent wipers do not work and wipers do not go to park position-- Larry

Sounds like the slip ring in the wiper motor has a strip missing from it,if so you need a new wiper motor,parts for wiper motors are next to impossible to find.
1helpful
1answer

Wiper motor needs replaced

should be right in front o the windshield uder the wipers. pop cowl off an replace the wiper motor
0helpful
1answer

99 town car intermitent wiper function inoperable

I performed a Web search using "lincoln wiper intermittent speed box" . There were diagrams and parts showing components. You should be able to find what you need after reading your search material. I once changed out a similar part in a 1984 Ford Thunderbird. My part was hanging behind the instrument panel and about midway up in the drivers' dash cavity.
Not finding what you are looking for?

3,668 views

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...