Tail light wiring problem on a 95 grand cherokee.

Have you checked the brake light fuse to see if there is power at the fuse and out of the fuse, also check the brake light switch for power in and out when the pedal is pressed, do that and get back to me.?

please don't break the brakes. ok?
you double posted this and its already answered.
why do that.?

• The tail/brake light are double filament. So it is important to use the precise numbered bulb that your Jeep recommends. If it is a single filament only the brake or tail light will work depending on the bulb used.
• It's also possible you happen to get a defective bulb.
• If that checks out then there is a brake switch by the brake pedal that could be malfunctioning or a loose wire/connection.

• Hope this helps and thank you for using FixYa.

Regards, Tony

most likely its the brake light switch located on the brake pedal . but check all your fuses first as it could be nothing more then a blown fuse

i would check the fuses, and then all of the connection to the bulbs , to make sure that there is not corrosion, or shortage in the wires.

the problem is with the bulb, what is happening is when you push your brake pedal with the lights off you are turning on you parking light side of you bulb, when the lights are on the parking light is already lit up so when you push the pedal you see no change. try a new bulb

could be the brake switch went out of it

hello,there is a switch onto the brake pedal ,probably this is not working,you can do a test to know if ,it is not working.Disconnect the two wire which goes in the switch,now after having disconnect it,now connect the two wires together,then see if the brake-light is lighting ,if so you know that the switch is not good and you have to replace it

you probley have a broken wire going to the tail light or bad ground

either the switch or fuse!!!