Throttle accelator engine startedbut no accelator

Any code's stored in the cruise control ?
DTC P0567 (4.8L, 5.3L, 6.0L, and 8.1L)
DTC P0567 (6.6L)
DTC P0568 (4.8L, 5.3L, 6.0L, and 8.1L)
DTC P0568 (6.6L)
DTC P0571 (4.8L, 5.3L, 6.0L, and 8.1L)
DTC P0571 (6.6L)
DTC P1574
The cruise control Resume/Accel switch is an input to the throttle actuator control (TAC) module. The TAC module uses the cruise control resume/accel switch signal circuit in order to detect when the driver has requested to accelerate the set vehicle speed or to resume the cruise control system. The TAC module detects a voltage signal on the cruise control resume/accel switch signal circuit when the switch is applied. The TAC module sends a serial data signal to the powertrain control module (PCM) via the UART serial data circuit. This DTC sets if the PCM receives a serial data signal from the TAC module indicating that voltage is present on the cruise control resume/accel switch signal circuit for longer than 90 seconds.

Does the vehicle have Throttle Actuator Control - electronic throttle control ?

Yes that is possible but you should have some one run a scan on it to pick up the code number then you will know what to fix

You will probably need tor replace the throttle position sensor....TPS... You can check and make sure the wiring is connected...Easy to find it is located on the side of your throttle body...usually on the right hand side, or toward the front of the car on your engine....

Year, make and model, please. How can it idle if you are cranking?

HI! Can you please tell me more what happens to the car? THis will help to sort out the problem. Thanks!

The ignition timing is not advancing at higher rpm.

That is the job of the ECM (Electronic control module).

Inspect / replace the ECM.

Yes, call the dealers parts dept. with the VIN and check for availibility.

LOOK at your throttle plate and see if it is wedged open. there is a piece riveted on that i have seen come loose and prop open throttle

check the throttle pos. sensor.

Hyundai Specific Trouble Codes Code Description P1100 Manifold Absolute Pressure (MAP) Sensor Malfunction (Open/Short) P1102 Manifold Absolute Pressure (MAP) Sensor Malfunction - Low Voltage P1103 Manifold Absolute Pressure (MAP) Sensor Malfunction - High Voltage P1147 ETS Sub Accel Position Sensor 1 Malfunction P1151 ETS Main Accel Position Sensor 2 Malfunction P1155 ETS Limp Home Valve P1159 Variable Intake Motor Malfunction P1171 Electronic Throttle System Open P1172 Electronic Throttle System Motor Current P1173 Electronic Throttle System Rationality Malfunction P1174 Electronic Throttle System #1 Close Malfunction P1175 Electronic Throttle System #2 Close Malfunction P1176 ETS Motor Open/Short #1 P1176 ETS Motor Open/Short #2 P1178 ETS Motor Battery Voltage Open P1330 Spark Timing Adjust Malfunction P1521 Power Steering Switch Malfunction P1607 Electronic Throttle System Communication Error P1614 Electronic Throttle System Module Malfunction P1632
Go to this page for generic codes that are for all OBD 2 systems

http://www.troublecodes.net/OBD2/Pcodes.shtml