Im having trouble with the pressure on my hydraulic clutch of my mazda soho. ive replaced both the cylenders, the one inside at the trust bearing as well as the one at the clutch peadal. i also found a leak on the brake fluid holder and im prerry sure there are no other leaks. is there any speacial way to bleed the clucth on this car? i checked the pressure plate and the pins did not look bent.
Sounds like you need to bleed the brakes again. Get a clear hose and put it on the bleed nipple on the slave cylinder so you can see the air bubbles in the fluid. bleed the clutch until there are no air bubbles in that clear hose. Even the little tiny bubbles can add up to lots of air in the system.
Testimonial: "great i am defnitly going to give it a try thanks."
SOURCE: 1989 mazda mx6 brake fluid leaking
That is your clutch master cylinder leaking. it will leak inside and cause a big mess. They cost between 47.00 and 75.00 depending on the manufacturer and where you buy it from. PBR's (an after market manufacturer) part number is JG83-41-400.
SOURCE: my mazda soho 121 1998 model speed can only go up 120
speed limiter most likely its a device they install to stop you being able to speed they also make rev limiters, or your engine can only go that fast which i doubt cos 130 pretty low for an engine stop at
SOURCE: bleeding hydraulic clutch
If you put in a new slave or master you need to bench bleed them first before installing or wont work
702 views
Usually answered in minutes!
×