Question about 1998 Audi A6

2 Answers

Audi Central locking pump. recoding/sync key and pump

Hello - I just bought a second hand central locking pump. I need to program the remote - I only have one key though. Is there still a way of doing it?

Posted by rob192 on

Ad

2 Answers

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

LEG CameraB (1989)
Bond 43 Opere

Posted on Feb 04, 2011

Ad

Ali Lif

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 3 Answers

I have change central lock on a4 audi how can programmer?

Posted on Aug 29, 2013

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Back doors locked shut. how do i open them.central locking innoperative


Use the key fob to open the rear doors by pressing the unlock function twice. If you need reprogramming instructions, use the following:

2002 Focus

  1. Turn the ignition from OFF to RUN 4 times within 6 seconds.
  2. Turn the ignition OFF. The system will chime to confirm programming mode.
  3. Within 20 seconds, press any button on first keyless remote. The system will chime once to confirm programming.
  4. Within 20 seconds, press any button on second keyless remote. System will chime once to confirm programming.
  5. Turn ignition to RUN to exit programming mode.

Mar 29, 2014 | 2000 Ford Focus

1 Answer

I have bought a replacement tranmitter for 2001 Suzuki Ignis Remote Central Locking System. I have an original that works but cannot Program the new one as per Owner's Manual given to me when the car was...


TRY THIS IF DONT WORK DEALERSHIP HAS TO REPROGRAM TRANSMITTER.REMOVE KEY FROM THE IGNITION SWITCH.CLOSE ALL DOORS.SWITCH IGNITION ON.WITH IN 10 SECONDS, SWITCH IGNITION OFF AND REMOVE KEY.WITHIN 20 SECONDS, PRESS AND RELEASE DRIVERS DOOR COURTESY LIGHT SWITCH 3 TIMES, SWITCH IGNITION ON, WITHIN 10 SECONDS ,SWITCH IGNITION OFFAND REMOVE KEY.LOCKS WILL CYCLE TO CONFIRM PROGRAMMING MODE ACTIVATED. PRESS THE UNLOCK DOOR BUTTON TO CONFIRM THE DOORS OPERATE FROM LOCK TO UNLOCK. REPEAT PROCEDURE REMAINING REMOTE TRANSMITTER.IF THIS DONT WORK DEALERSHIP WILL HAVE TO REPROGRAM NEW REMOTE.

Apr 18, 2011 | 2001 Suzuki Swift

1 Answer

Just bought a x reg ford puma but the key fob does not work, bought a new battery and fitted it, needs re-programming but don't know how to do it.


Telephone: Fax: VAT Registration No.:
Infrared remote control
NOTE: Infrared emitter can be seen at front edge of key.
System operation
Switch ignition ON. Ensure clock LED illuminates for 3-5 seconds. Pressing key lock button once activates central locking and alarm. Pressing key lock button twice within 3 seconds activates double locking system.
Programming
When
Key batteries completely discharged. Key batteries not replaced within 15 seconds. Key added or replaced. System malfunction.
How
Obtain all keys fitted with remote control. Turn ignition switch to position I. Wait approximately 10 seconds. Ensure clock LED illuminates.
NOTE: LED illuminates for approximately 5 seconds.
Switch ignition OFF and remove key, while LED illuminated. Programming mode activated for approximately 20 seconds (LED illuminated). Proceed as follows: Point key at receiver (located near interior lamp). Press and hold unlock button Fig. 1 [1]. After approximately 1 second key LED will flash once [3]. Press lock button 3 times Fig. 1 [2]. Release unlock button Fig. 1 [1]. Continue to point key at receiver until LEDs in clock and key have flashed 5 times. Ensure LED remains illuminated. Repeat above procedure within 20 seconds to program remaining keys. To exit programming mode and extinguish clock LED: Switch ignition ON and OFF. Wait approximately 20 seconds.
NOTE: A maximum of 4 keys can be programmed. Fig. 1
Radio frequency remote control
System operation
Switch ignition ON. Ensure clock LED illuminates for 3-5 seconds.


Pressing tailgate release button twice within 3 seconds unlocks the tailgate - if fitted. Pressing key lock button once activates central locking and alarm. Pressing key lock button twice within 3 seconds activates double locking system. Interior lamp illuminates when disarming system.
Programming
When
Key added or replaced. System malfunction.
How
Obtain all keys fitted with remote control. Fasten seat belts and close all doors. From position I, turn ignition switch as follows: To position II. To position I. To position II. To position I. To position II. To position I. Programming mode activated for approximately 20 seconds. LED or fog lamps ON warning lamp illuminates (some models) or the system will emit an acoustic signal to indicate start of programming mode. Proceed as follows: Type 1: Press and hold unlock button Fig. 1 [1]. Type 2: Press unlock button Fig. 2 [2]. Ensure clock LED or fog lamps ON warning lamp flashes (some models) or wait for acoustic signal (indicates correct programming). Wait 2 seconds. Repeat above procedure within 20 seconds to program remaining keys. To exit programming mode: Switch ignition ON. Wait 20 seconds.
NOTE: A maximum of 4 keys can be programmed.

Aug 25, 2010 | Ford Focus Cars & Trucks

2 Answers

The doors do not open by remote control key(BMW 740il 1996 model)


Programming
When
Key batteries completely discharged. Key batteries not replaced within 60 seconds. Key added or replaced. DO NOT press remote control buttons during battery replacement.
How
Unlock vehicle. Enter vehicle. Close driver's door. Switch ignition ON and OFF. Remove ignition key. Press and hold unlock button Fig. 1 [1]. Press lock button Fig. 1 [2] briefly 3 times within 10 seconds keeping unlock button [1] depressed. Release unlock button Fig. 1 [1]. Some models: LED Fig. 1 [3] flashes slowly for 10 seconds. Some models: Central locking system locks and unlocks rapidly to indicate correct programming. Some models: Repeat above procedure if central locking system does not work and LED does not flash or LED flashes continuously

To change batteries remove panel back of key then screws on plastic bar
Batteries are available from your local motor factor shop
You might not need new batteries try re programing as described above

Apr 24, 2010 | 1998 BMW 7 Series

2 Answers

2002 bmw 530i key does not (remotely) unlock doors or trunk but they work fine manually.


Unlock vehicle. Enter vehicle. Close driver's door. Switch ignition ON and OFF. Remove ignition key. Press and hold unlock button. Press lock button briefly 3 times within 10 seconds keeping unlock button depressed. Release unlock button. Some models: LED flashes slowly for 10 seconds. Some models: Central locking system locks and unlocks rapidly to indicate correct programming. Repeat above procedure if central locking system does not work and LED does not flash or LED flashes continuously.

Mar 09, 2010 | 2002 BMW 5 Series

1 Answer

Just bought a 2003 Nissan Navara 2nd hand. Has central locking but no remotes were handed with it, how can i find out if this vehicle has remote central locking or not


The remote should be built into the key. If not the remote central locking would be after-market. After-market remote central locking is part of an anti theft device so the fob you get with the key's has two function's it opens the door and disables the imobliser. If it had a fob and it was'nt with the key's then the ignition would'nt work so the car would'nt start. So it dosent have remote locking. Before giving up check the dash and suround's for a small either green or red light which looks like it was installed after-market if their is one then it still may have remote locking but was disabled for some reason but although it is there unless you really need it don't bother with it because you will need to get it rewired then get a fob which will need to be programed. Hope this help's Cheer's

Sep 12, 2009 | 2003 Nissan Frontier Crew Cab

2 Answers

Broken key fob


bought second hand fob now being reprogramed

Apr 12, 2009 | 1997 Honda Accord

1 Answer

Bought a second hand fiesta but the previous owner had lost the central locking key .how can i get one


you'll need to go to a ford dealer to get remote key & for them to programme in.

Mar 25, 2009 | Ford F Cars & Trucks

1 Answer

Car won't start.


Hello again, You could now have a driver authorization problem.
1. Plug your central locking pump back in.
2. Make sure that your remote batteries are good.
3. Lock and unlock the car with the remote.
4. Try to start car.
5. If no start you may have to synchronize the anti-theft system.
6. Point remote at the interior rear view mirror, press button on remote twice and turn ignition key key on within 30 seconds.
7. Turn key off and then back on and try to start car.
If car starts, you will need to find out why the pump won't shut off.
You may be able to unplug the pump after you are able to start the car but this I am not sure of.
CYA, Gator241

Mar 01, 2009 | 1995 Mercedes-Benz E-Class

Not finding what you are looking for?
1998 Audi A6 Logo

Related Topics:

1,629 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14846 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...