2005 Cadillac CTS Logo

Related Topics:

A
Anonymous Posted on Jan 19, 2018

Had new engine installed in my 2005 cts-v when I picked up the car the abs,traction control and brake light are on, then theft light came on the screen said service theft system, then stereo would not stay on kept blinking on and off then lost temp and fuel guage went to zero. what could cause this.

1 Answer

DROPNDEAL

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Cadillac Master 2,931 Answers
  • Posted on Jan 19, 2018
DROPNDEAL
Cadillac Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jul 19, 2009
Answers
2931
Questions
0
Helped
931762
Points
21770

Your mechanic caused this. Take it back and have them fix it.
Major work like this done at a dealer will also get you a 12 month - 12,000 mile warranty.

5 Related Answers

Anonymous

  • 88 Answers
  • Posted on May 21, 2009

SOURCE: abs and traction control light

have to ask is the relucter for the abs sensor on the axle or rotor

Ad

Anonymous

  • 27 Answers
  • Posted on Jun 10, 2009

SOURCE: ABS LIGHT AND TRACTION CONTROL LIGHT ON DASH

make sure u didnt break a wire, there are sensors on the brakes, make sure theyre plugged in

Anonymous

  • 651 Answers
  • Posted on Jul 01, 2009

SOURCE: brake light abs light traction control light all

you'll have to have it diagnosed at a repair shop to pinpoint the source. sorry, but thats how they make them. you could buy your own but it'll cost about 200$

Anonymous

  • 1 Answer
  • Posted on Sep 15, 2009

SOURCE: abs light/traction control light

You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.

Anonymous

  • 1 Answer
  • Posted on Dec 29, 2010

SOURCE: service stability system light flashes

i hav the same problem wit my 98 deville wat did u do to fix it and wat was the cheapest way. Also did u have anyother problems wit ur car during the time u were driving it wit these lights on

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2005 chevy uplander ABS control module wire harness where is it located, what does it look like? if damaged will it prevent vehicle from starting

This will not prevent the car from starting - will cause ABS light, traction control light (if equipped) and maybe weird low speed braking. Usually the fault of the lights is a bad wheel bearing/hub very common.

The EBCM (Electronic Brake Control Module) is mounted to the BPMV (Brake Pressure Modulator Valve) located at the left front (lower) engine compartment.

It looks like a (thick) flat black box.
0helpful
1answer

Abslight stays on. How to fix? This is a2007trailblazer?

First you need to have EBCM - electronic brake control module check for DTC'S - diagnostic trouble code's . If the light is on there is a code stored . I think most part stores can do this and for free . After you find out what code is stored , looking up that code in service repair information for diagnostic trouble shooting chart would be next step . There are a few codes too.
DTC C0035 or C0040
DTC C0045 or C0050
DTC C0110
DTC C0131
DTC C0161
DTC C0186
DTC C0196
DTC C0201
DTC C0240
DTC C0241 or P0856
DTC C0244 or P1689
DTC C0245
DTC C0283
DTC C0287
DTC C0290 or C0292
DTC C0455
DTC C0550
DTC C0558

Find the code do the diagnostic's , fix the problem , wiring issue's , a sensor , bad module ,what ever it is . The light will go out then . Here is a sample of code discription .
• DTC C0035 Left Front Wheel Speed Sensor Circuit
• DTC C0040 Right Front Wheel Speed Sensor Circuit
0helpful
1answer

My 2003 cadillac cts was stuck in park and abs brake and traction lights are on replaced shifter wire car is not in park anymore but abs brake and traction light is still on. Also, resurfaced rotars and...

Low brake fluid level could cause that. Bad ABS wheel sensor. Brake switch. Go to Autozone and ask them to put the scanner on and see what codes you're getting.
0helpful
1answer

Engine light and traction control light on 2006 chevy hhr

Traction control usually uses part of your ABS brake system to function. Sometimes a dirty (or worn out) wheel sensor is the problem that triggers both "check engine" and "traction control"...This can be verified with the proper diagnostic meter, and many shops will perform this test for free...unfortunately the free check at the auto parts stores does not include reading the ABS/Traction sensors...sensor cost is about $65. sometimes they can be cleaned. Hope this helps.
0helpful
1answer

2006 CTS Engine light on.

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS, MIL, CEL and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System, MIL Malfunction Indicator Lamp, CEL Check Engine Light.

0helpful
1answer

2003 cts, i took it for a safety and they did not disable traction control, when putting the vehicle on the hoist, now the traction control and abs lights come on randomly, but turn off when i restart the...

well while putting the car on the lift, traction control does not need to be disabled, and will not cause the abs/traction light to illuminate, these cars are known to have terrible wheel speed sensors that are brittle and tend to brake or malfunction for no apperent reason, and the wheel speed sensors are what control your abs and traction conrol units and they are normally what make the light come on on your dash, the warranty on the sensors was prolonged for that reason, so depending on the mileage of your car they might be covered, hope this helps
7helpful
1answer

What if the traction control and anti lock break system light is on

You most likely have a problem with one of the wheel speed sensors, the related wiring, or the ABS system itself. The traction control and ABS system both work together and rely on the same input information to work. A fault in the ABS system will cause both the ABS and TRAC control lights to illuminate and both systems will be disabled until the fault is gone. I would have a good service facility or dealer look at this one. One quick check you can do is to make certain that the brake fluid master cylinder is properly filled with brake fluid because if it is low enough it can also cause the systems to be disabled.
0helpful
1answer

ABS and Traction Control Light On

Because the brakes were changed, either one of the sensors were broken when removing brakes or it has set a code. Go to your local autoparts store and have them reset the code. See if it comes back on. If it does you will need to look at the ABS sensors on each wheel and replace if damaged
0helpful
1answer

ABS TURN LIGHTS COME ON

need to get abs codes read. it will tell you what wheel to look at.
1.bad wheel bearing, sensor is part of bearing.
2.broken wires to sensor.
3.traction control part of abs
Not finding what you are looking for?

294 views

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...