SOURCE: Replacing head gasket on 1995 honda civic, require torque specs and secquence
wow. a lot of bad information on this site. Refer to a manual for the proper torque sequence. The civic I believe is a two step torque procedure. First 22 ft lbs, than 53 ft lbs.
SOURCE: torque specs needed
on a 1999 Honda Accord, the torque for the front axle nut is 181 ft lbs. For the most part, sung it up and then go a bit further. If you are reusing the old axle nut, tighten it until the stake mark on the nut lines up with the notch in the axle (make sure to re-stake it). check out alldata.com/diy for individual vehicle subscriptions which have all the repair info you will ever need. If you had the steering knuckle out, tighten the balljoint nuts on the upper and lower control arms until they are tight and then tighten until the hole lines up to recieve the cotter pin.
SOURCE: Torque specs for 96 Honda Accord 2.2L
the main bearings bolts is to 1st step 30Nm or 22lbs ft and the last step is 75Nm or 54lbs ft in this tighten secuence. 9 3 1 5 7 on the top bolts and........ ........ ........ ... 8 6 2 4 10 botton bolts and the connecting rod 45Nm or 34 lbs ft i hope be help you
SOURCE: Oil pan drain plug stripped 1988 Honda Accord
go to any part store and tell them what happend they will sell you a kit that can fix this or you can try to re tap the hole and get a new oil pan plug
601 views
Usually answered in minutes!
×