Question about 1988 Dodge B250
Yurn the engine over by hand until the 0 timing mark on the crank lines up with the pointer. Trace you #1 plug wire back to the cap, lift the cap and see where the rotor is pointing. If it's not at #1, or very close to it, you are right. #1 is the front plug on the driver's side. If it is lined up then you have another problem, likely related to overheating.
Posted on Oct 24, 2013
The order should be stamped on your intake manifold right under the air cleaner.
My '97 1500, 5.2, 318 firing order is 1-8-4-3-6-5-7-2
Hope this helps
Posted on Sep 17, 2008
First place I'd look is at the thermostat. However, if the hose did not rupture in a normal manner and blew apart, I'd also suspect that you may have a blown head gasket. In that case, compression is entering the cooling system which is not designed to handle such high pressures, therefore causing the hose to explode). This will also result in rough running you observed.
Posted on Apr 18, 2009
if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10
Posted on May 09, 2009
Tips for a great answer:
Aug 25, 2017 | Cars & Trucks
Apr 06, 2014 | Dodge Ram B150 Cars & Trucks
May 14, 2011 | 1985 Dodge Ram 3500
Aug 02, 2009 | 2002 Ford Explorer
May 24, 2009 | 2002 Jeep Grand Cherokee
Aug 07, 2008 | 1985 Chevrolet K2500
68 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: