Question about 2000 Chrysler Town & Country
Posted by Anonymous on
My service manual states that the '02 T+C has a combination turn signal/hazard flasher/daytime running lights module which is located on the junction block, adjacent to and left of the steering column. To access it, you must remove the steering column lower cover and knee pad panel. There is also a fuse for turn signal/hazard flasher. If none of them work, check the fuse 1st.
Posted on Jul 18, 2009
I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.
Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.
If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)
Your going to replace it anyway, whats the harm?
Posted on Jan 28, 2010
The turn signal flasher is worn out. The turn signals have their own flasher. It is usually on the drivers side of the vehicle under the dashboard. It is normally a cylinder about 1 inch in diameter and 1inch tall that has two prongs on it. My advice would be to go to the parts store and get a new turn signal flasher for your car. Look for something under the dash that looks like it and exchange them.
Posted on Apr 29, 2010
Tips for a great answer:
Feb 15, 2016 | 2002 Chrysler Town & Country
Feb 08, 2014 | Nissan Cars & Trucks
Oct 03, 2012 | 1996 Chrysler Town & Country
Jun 27, 2011 | 2000 Chrysler Town & Country
Feb 03, 2011 | 2001 Chrysler Town & Country
Sep 24, 2010 | 1995 Lincoln Town Car
Apr 30, 2010 | 2006 Chrysler Town & Country
Apr 29, 2010 | 1996 Chrysler Town & Country
Jul 18, 2009 | 2003 Chrysler Town & Country
124 people viewed this question
Usually answered in minutes!