2000 Camry Gas tank spits gas out 2-3 times before taking it

Try adjusting the valve that holds the tank in place, make sure the hose is not kinked when fueling

on every station? try another pump and see.

the decision to stop is on the pump. not your car.

There's an air return pipe that's supposed to prevent this. Look on the filler neck for a finger sized secondary pipe or hose. Make sure this is not damaged or otherwise blocked.

Spit back can also occur when the tank is nearly empty on hot days. The tank is full of gas vapour and this pressure has to go somewhere. Try adding gas slowly for a couple of seconds, then stopping. The added gas is colder and will cause the vapour to condense, after which you can usually add gas at normal speed.

If I were you, just take out the old gas and put some fresh fuel in. Next time, keep a few cans of SeaFoam in the car. It stabilizes the fuel for up to 2 years (1 oz for each gallon).

theres a one way valve in the filler neck of the gas tank and that is spring loaded. it maybe getting jammed up. will need to remove filler necvk and check it's operation. pretty much only thing down there that it could be.

The tire shake may be a tire that is out of balance or a bad outer tie rod end. The tank has pressure on it and when you take the cap off the pressure is relieved. Try putting the nozzle in not so far in to pump gas.

Sound to me like you have water in the bottom of your fuel tank. when you fill it the water is mixed with the gas until it settles. put some gas line antifreeze into the fuel tank, may take several bottles. but this should help. if not you will have to have tank taken off and drained.

there is a breather pipe running long the filler pipe, if u look at the furl cap there should be a small hole that lets out air as u fill up, i think that this is blocked .

More than likely you picked up debris off the bottom of the tank. You will need to replace the inline gas filter.

this would be a vent problem your vent tube is kinked or clogged should see a line leading back into the filler neck this is the vent