It sounds like u have a bad ground connection somewhere.I woud start with the battery and check all your wiring connections it could just be a loose connection somewhere.
Could that.male it short out and have a power hiccup while driving?
Make
yes any loose connections or bad grounding will do that.
Thank you, will check ASAP I see there is corrosion on the terminals so I will investigate there.
×
SOURCE: car alarm preventing car from starting
1999 CONCORDE: check the battery terminals probably they are not tight enough...something like that happened to me just the lights turned on and the car seemed to be dead, the battery is still ok since then. I just needed to buy new terminals.
SOURCE: 1995 Chrysler Cirrus Lxi--no buS on odometer and gauges don't work
Check all connections on the back of the guage cluster. The red one usually causes the no bus, meaning there has been a momentary loss of connection. This is a common problem on this model because the connection pins will wallow out the holes where they pass through the circuit board.
SOURCE: 2000 chrysler concorde will not get out of gear.
Change the shift cable (cable from shifter to transmission) Also spray some WD40 on the shift linkage on the trans and work it back and forth to loosen it up before you put the new cable on. Good luck
SOURCE: 99 Chrysler 300M gas gauge droping down to empty
you are going to have to replace the sending unit for the gas gauge, it is located in the fuel tank.
SOURCE: Chrysler 3.5 won`t rev past 2500 rpm?
remove the aircleaner intake hose and, check the intake air control flap for free movement
201 views
Usually answered in minutes!
×