Window went down and wont go up. I have taken off the door panel to try to see the problem.
Vehicles with power windows
Vehicles with manual windows
All Vehicles
Vehicles with power windows
All Vehicles
Vehicles with power windows
Vehicles with manual windows
All Vehicles
Vehicles with power windows
SOURCE: 2002 Buick Lesabre drivers side window went down,
A couple of things to add to tinyp's solution. For Buicks, the regulator is bolted in, not riveted, which makes removal easier. Also, you'd better get used to this, as I have replaced 3 out of 4 window regulators on my 2002 LeSabre.
SOURCE: power window problems!!!!! window stuck down and it looks like
use the switch from the other side connect just use it and unplug it..it the switch does not work go to motor
SOURCE: 2005 chevy impala rear driver power window stopped going up.stuck
If neither switch works it is a bad connection at the motor or bad ground or a bad motor. Remove the door panel unplug the motor push the switch and see if there is 12volts on the wires if there is the motor is bad There are small brushes in the motor that go bad tap on the motor while pushing the switch if it works that way replace it
SOURCE: Removing a door panel on a 1988 chevy C15 truck
There should be a couple of screws on the arm rest that you need to remove and probably one on the door handle then you need to find something to pry the panel off with, without breaking the plastic clips. They make a special tool for this that you can buy for just a few dollars at any auto parts store. If attempting to do it without the right tool be careful not to break the clips.
SOURCE: REMOVING A DOOR PANEL
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
Before you replace anything, inspect the connector pins in both the driver's door switch and the passenger door switch. If you don't find any problem with these connector pins, replace the driver's door control switch.
1,447 views
Usually answered in minutes!
×