Question about Jeep Wrangler
Posted by Anonymous on
Hi Dava224 i had the same problem with my 1989 CJ. when it was cold out i would pump the gas pedal 3-4 times before turning the ignition. it puts a small amount of fuel in the motor without stalling it out. it wont start as hard. another good idea is to keep some fuel stabalizer in the tank everytime you fill up. hope this helps
Posted on Jun 28, 2009
The dealership has at their disposal far more and better testing equipment than most normal repair shops...their technicians are supposed to be well trained and competent...Yet, in one week you note that they did about a half days actual work and in doing what they did, have not repaired your problem? Who is working on the vehicle...the janitor or a lube tech? And, I'll bet that they are going to charge you for not fixing it!!! You would likely do better getting yourself a decent manual and a digital volt/ohm meter, and going through the system item by item till you find it yourself. Or see if you can find a decent independent shop that specializes in Jeeps in your area...You may do better there. There isn't enough info for me to offer anything meaningful, but often the problem is common to a bad crank sensor, ignition switch or auto shutdown relay...but without real testing, I could be way off with this. Also...don't forget there is an engine underneath the electronics that needs to be checked as well.
Posted on Jul 28, 2009
Replace the light bulb socket, that happen it to me too, it was driving and start it working fine. me crasy, but we replace the socket
Posted on Nov 17, 2009
CHECK BATTERY VOLTAGE.IT SHOULD BE 12.5 VOLTS.IF BATTERY OKAY.YOUR FUEL FILTER COULD BE STOPPED UP.OR YOU NEED NEW PLUGS + WIRES + CAP AND ROTOR.
Posted on Apr 18, 2010
SOURCE: 1995 JEEP WRANGLER 2.5L HARD
When you're trying to start it for the first time of the day, look at the dash to see if the check engine light is on when you first turn on the ignition. If the check engine light is not lit up, your Jeep ecu is in need of repair and the vehicle will not start until that check engine light finally comes on.
Posted on Apr 19, 2011
Tips for a great answer:
Oct 05, 2015 | Jeep Cars & Trucks
May 22, 2014 | 2003 Jeep Wrangler
Mar 19, 2014 | 2007 Jeep Wrangler Unlimited Rubicon 2...
Mar 13, 2014 | 2007 Jeep Wrangler Unlimited Rubicon 2...
Dec 03, 2010 | 2010 Jeep Wrangler
Aug 16, 2010 | 2009 Jeep Wrangler
Mar 03, 2010 | 1997 Jeep Wrangler
Nov 27, 2009 | 2007 Jeep Wrangler Unlimited Rubicon 2...
Feb 27, 2009 | 2008 Jeep Wrangler
155 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: