Get the help from repair manual and to the manual go to the given link http://toolsnyou.com/
SOURCE: 98 Ford Contour not charging
I dont know if yours is a 4 or 6 cyl. On the back of the motor by the firewall there is a 175 amp mega fuse inline on the positive cable comming from the battery. On the 4 cyl it is below the air box center of the back of the motor. On the 6 cyl, it is below the coil pack on the center back of the motor. Be sure to disconnect the negitave battery cable before you attempt this. There is a 3 inch long cover you pop off and you will see it. It takes a 10mm socket to unbolt it. Remove the fuse and ohm it out, if there is no continuity, you have a bad fuse, replace it. I have had 3 people replace their bats and alts ($350 in parts) just to find out it still had the problem. An $8 fuse. Good luck and hope this helps..
SOURCE: a 1996 ford taurus with no spark
Hello you say no spark again well in the past i have replaced coils on Fords same day the coil pack quit!.So perhaps return it as a faulty pack.Manufactures still makeing defective parts!.Also if you have service engine light on you should have a OBD 2 scan to retreve any electrical faults might be.
SOURCE: I have a 1995 Ford Contour. It will not start. We
could be crank sensor could be just fouled spark plugs need to check for spark out of coil
SOURCE: have 98 ford contour, 2.0 DOHC, 4 cylinder. Got a
You have an oxygen sensor code. This code by the way is not for a signal problem rather it is the heater part of the O2 sensor. Check fuse #13 to see if it is blown. This is a 30 amp fuse. If fuse is ok then put a meter on the two white wires on O2 sensor and check for 12V when the ignition is on. Your code is being tripped due to a heater malfunction and unless you determine if power exists you cannot go any further. Hope this helps
52 views
Usually answered in minutes!
×