Replacing Spark Plugs Jeep 4 0L
Easy job. Remove bolts holding coil pack. Disconnect Plug from Coil Pack. Remove sparkplugs. Check Gap on new plugs. Install them and put the coil pack back on. Just did it myself last weekend.
SOURCE: where are the spark plugs for 2006 jeep wrangler
in the cylinder head under the ignition coils that are over each plug, remove the coil to access the spark plug (one coil for each plug)..
SOURCE: 97 jeep wrangler getting spark not fuel. I
Sounds good ninemil, I would also check for any bent or disconnected fuel lines that would restrict the fuel flow as well. I do not know if this has a fuel pump assembly but you should be able to hear it actuate on when the key is in the "on" position. How did it act before you shut it off? Was it harder to start? Make sure you buy a high quality pump (Carter) many of those cheaper brands will fail trust me.
Testimonial: "It actually had no spark or fuel . It was the computer. Thanks for answering"
SOURCE: 2006 Jeep Wrangler cigarette lighter not working
Check for un-isulated connection on the hot wire lead. It might have been after-market but on mine the connection would short out, blowing a fuse. 1 inch of heat shrink tube fixed the problem.
SOURCE: 1988 Jeep Wrangler starting problems. I replaced
you are saying it is getting spark, and fuel, right? If it is getting spark, and fuel in to the throttle body, check compression-make sure the Mass Air Flow sensor is plugged in, and double check your spark-you say you replaced all those ignition items, but do not say that you have spark.
746 views
Usually answered in minutes!
×