Have a constant problen with ford escape alternator 2nd one i have put in brand new is this a common problem with the ford escape

There is no fusible link. Locate "Fuse B" 120 AMP located in the battery junction box located at front left corner of engine compartment. With engine off, key off, both sides of the fuse should measure +Battery Voltage. Reference negative post for testing.

The flashing could be caused by the alternator...that would explain why the battery light is on.

CHECK SEE IF THE GROUND IS GOOD AND TIGHT

most likely a bad alternator

Fix your car right away by clicking the link I attached
2008 Ford Escape Workshop Repair Service Manual PDF Download

Check the alternator fuse,make sure all wires on alternator are in the right place, have auto zone check your alternator,

P0732 and P0734 indicates gear ratio errors in 2nd and 4th gears, basically no 2nd and 4th gear. The one thing 2nd and 4th gear has in common is the band, the band is known to break, this is a common failure with this transmission and happens on a regular basis.

You need to remove the transmission to repair it.

HAVE BATTERY CHECKED IT COULD BE BAD OR HAVE A DEAD CELL IN IT.ALSO CHECK ALTERNATOR OUT PUT.IT SHOULD BE 13.5 TO 14.5 VOLTS. IF NOT THE ALTERNATOR ALREADY BEEN REPLACED YOU HAVE BLOWN FUSE OR FUSELINK.OR THE ALTERNATOR WIRES COULD BE DAMAGED OR BROKE.MAKE SURE YOUR ALTERNATOR BELT NOT SLIPPING.IF ALL IS GOOD.YOU NEW ALTERNATOR COULD HAVE A FACTORY DEFECT.IT COULD BE BAD.

Have the whole battery/charging sytem tested. If it has an external voltage regulator or a bad battery, these things can kill a perfectly good alternator.

there should be 2 bolts that hold it in place maybe 3 but you need to loosen the top one and loosen the bottom one to allow slack in the belt.you take the old belt off and put the hew one on and then u need a prybar to put pressure against the new alternator to take the slack out of the belt and tighten the bolts up at the same time. on the back of the alternator you will find 2 screws that have to be taken loose and put back the same way on the new alternator. make sure u take the pos battery cable loose from the battery before u begin