2003 Honda Accord Logo

Related Topics:

Anonymous Posted on Aug 29, 2013

Honda accord 2003 EX engine vibrate when in drive and when the aircondition is on

1 Answer

Allan

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Scholar:

An expert who has written 20 answers of more than 400 characters.

  • Expert 79 Answers
  • Posted on Oct 15, 2013
Allan
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Scholar:

An expert who has written 20 answers of more than 400 characters.

Joined: Feb 27, 2009
Answers
79
Questions
2
Helped
63503
Points
128

If your having an engine vibration while driving and it seems worse with the air conditioning is on, my initial thought would be to have your engine mounts checked. Typically, the vibration you're describing is due to broken engine mounts.

5 Related Answers

paulcet

  • 12 Answers
  • Posted on Jul 14, 2008

SOURCE: where is the o2 sensor located on a 1991 honda accord ex 2.2 engine

Further clarification on the O2 sensor location: It is in the exhaust pipe, under the center of the car, on top of the pipe, just aft of the oil filter.

Ad

Anonymous

  • 26 Answers
  • Posted on Jul 21, 2008

SOURCE: 1992 honda accord ex timing belt

yes this engine is a interference engine. Make sure you did not bend the valves when it boke.

Jerry Parmanand

  • 449 Answers
  • Posted on Dec 17, 2008

SOURCE: Where & how to install thermostat in honda accord ex 1992

you need to follow the upper hose that lead from the radiator to the engine, there is two bolt that connect the thermostat housing to the block loosen the bolt using a 10 mm socket with ra-chet. Make sure that the engine is cool off before attempt to do this you will lose coolant but that's ok you will add the coolant when you finish replacing the thermostat. start the engine with the radiator cap off then add coolant slowly and cap it, then fill the reservoir up.

note the way you remove the thermostat that's the same way you will put the new one so pay attention when you remove the old one good luck.

Anonymous

  • 25 Answers
  • Posted on Mar 17, 2010

SOURCE: blower motor 1991 honda accord ex

the blower motor is located behind and under the glove box. its held to the blower housing by three screws. remove the three screws and the motor will slide down and towards you. to test the motor. apply power to the yelllow/black wire and ground to the blue/red wire. the motor should run. if not you prob have a faulty power resistor. 0881be0.jpg

jason592

Jason Lepak

  • 53 Answers
  • Posted on Apr 24, 2012

SOURCE: honda accord ex 2001 check engine light suddenly came on, car started to idle roughly

If it's running rough, chances are that it's misfiring. If the Check Engine light is flashing/blinking, it is definitely misfiring.
If that's the case, drive it as little as possible... Or straight to the mechanic because the more you drive it while it's misfiring, the higher the chance is of you ruining your catalytic converter.

I’m happy to help further over the phone at https://www.6ya.com/expert/jason_00b31cc8f593773a

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

What could make the steering of my Honda accord 1993 vibrate each time l engage d gear to drive this get worst when d ac is on the vibration is more noticeable.

Sounds like bad engine/trans mounts. The more load you put on it the more vibration engine makes. If mounts are bad, vibration will transfer to body and steering
0helpful
1answer

Where are the fuel lines located (primary/return) on a 2003 honda accord ex in the engine area

find your fuel rail and check at both ends, should see lines going in 1 end and 1 at other end of fuel rail, also you can follow lines from fuel tank to engine area
1helpful
1answer

The engine vibrates, makes the dashboard and doors vibrate a lot when it comes to a stop. And it gets even worst when i turn on the A/C, but when is on drive is fine it dosn't vibrate. ONLY when IT comes...

If you have had the timing belt changed they might not have replace the balancer belt and it may have snapped. Or, the balancer belt might not be set correctly.
1helpful
1answer

Cant find where the knock sensor is located on a 2006 Honda Accord ex 6 cyl is?

I believe it is located under intake runner on passenger side like the 6 in an.MDX. It has to attach to the engine block to pickup vibrations from engine knock.
0helpful
1answer

08 accord ex-v6 auto. engine vibration @ idle in park or (gear at stop) when engine is cold to warm until it fully warms. dealer states it's normal. dealer showed me another accord with similar shake.???...

I've got an 08 4cyl and it doesn't really have the vibration unless its really cold. Usually if I give it about 30 seconds...when the rpms start to come down, its barely noticeable.
1helpful
1answer

Please My Honda Accord 2003 model jerks and also do viberates

It sounds like something is loose...That may be causing your vibrating problems with the engine. You need to life the hood and grab anything that should be bolted down grab it and gently but firmly pull on it. If it moves then you will see it right then and there. Or it can be on the inside of the motor also. The jerking can be from bad fuel....
0helpful
1answer

I have problem mi 91 honda accord ex coupe has vibration when im driving 55 & up im replaced l/f axle,control arm & balance the tires

Is there vibration in steering wheel? Check for bent wheel then check axle...again. Remans are not always good and new ones are just a bit more expensive. Also, check the output shaft bearing for excess play. Also try rotating tires to confirm it's not there.
3helpful
4answers

Honda Accord 2003 - Engine and steering vibration

My 2003 honda accord was doing this too. The problem is the inner CV axle bearings. The fix is to replace both CV axles. When you choose your CV axle choose a new one not a reman, there are known problems with used CV axles. It's not a hard job. It took me 1hr to do both sides on a lift.
Not finding what you are looking for?

228 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...