Question about 2002 Nissan Sentra

1 Answer

Dies while driving

No start no injector pulse

Posted by rebelrexster on

Ad

1 Answer

AV Vrgs

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 29 Answers

If the engine stalling occur when the engine is hot the most probable cause is a vapor lock, this is when gas boils before it reach the engine, when the engine is extremely gets hot, the gas boils and an air bubble is formed which causes the air/fuel mixture to be too lean, too much air and not enough gasoline, thus making the engine to stall. When you experience vapor lock, just let the engine cools down, have a mechanic to check your cooling system it might cause the engine to get extremely hot.

Engine stalls while driving a vehicle with carburetor

Posted on Apr 10, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have no injector impluse


no injector pulse - DodgeForum.com

dodgeforum.com/forum/2nd-gen-ram.../269362-no-injector-pulse.html
Nov 21, 2010 - no injector pulse 2nd Gen Ram Tech. ... but was running and driving fine before. as far as i can tell i have no injector pulse. tested with a noid ... No spark AND no fuel injector pulse ONLY when van is cold ...
Nov 18, 2013
2000 ram 1500 Has spark but no injector pulse wont start ...
Jun 25, 2013
v10 RAM no start....frustrated
Sep 19, 2011
help - no spark, no injector pulse, no run
Oct 30, 2009
More results from dodgeforum.com

No injector pulse 02 Ram 1500 - DodgeTalk : Dodge Car Forums ...

www.dodgetalk.com > ... > 3G Dodge RAM - General Talk
May 30, 2012 - No injector pulse 02 Ram 1500 3G Dodge RAM - General Talk

Oct 23, 2015 | Dodge Cars & Trucks

1 Answer

1989 Beretta 2.8 the guy I bought it from said he was driving and it died. He had a new fuel pump put in and now it fires and dies. It will start and run on ether


Have you got normal fuel pressure at the injectors ?
Are the injectors getting power and ground pulse from the computer ?

Sep 16, 2015 | Cars & Trucks

1 Answer

No injector pulse


what vehicle? injector pulse controlled by computer. the computer recieves a pulse from crank angle sensor, or distributor pick up, etc.
then controls injector pulse. Mass air flow on some vehicles determines spray pattern

Jun 29, 2012 | 1991 Chevrolet Cavalier

1 Answer

1990 dodge dakota 2.3 v-6 auto-----just put new fuel pump and filter, and everything back to normal but still not getting fuel to tb inj.? cranks over but still nothing.---i can pour gas directly in and...


2.3 V-6? You should be a 2.5 V-6 whether you have a TBI (throttle body injector) or sequencial, If there is no injector pulse then move your inspection to the distributor, there you will see a distributor pick up, this controls spark and fuel, and yes the rule is if there is no spark then there is no fuel but you case is special you have spark and no fuel pulse,you will need to inspect this for corrosion as it can give spark and no fuel injector pulse,that is one area of no injector pulse, Then inspect the MAP sensor (your a spped density), the most common complaint for a map sensor is it start then dies. inspect this sensor its mounted on the firewall make sure the vacuum hose is connected, and that it is plugged in.

May 22, 2011 | 1990 Dodge Dakota

1 Answer

My 01 sable starts and dies and thats all it does due 2 injector pulse gets weak but if i unplug all of them it has good pulse but if i even plug any one of them it looses pulse after a few seconds


Check all injectors with a needle stethoscope. Unplug electrical connector of bad injectors, and check the signal with (injector check light). The light must pulse. If not might be a bad computer. If yes replace bad injectors with new one. Hope will help.
This is a free advice. Do not rate me.

Sep 08, 2010 | 2001 Mercury Sable

1 Answer

Isuzu trooper starts briefly then dies


check your fuel delivery from the pump to the "dry" pulsing injectors leave the crank sensor alone! open the intake and, spray either (engine start) into the engine then attempt to start; it should start and, run until the either is used up then die. most likely your fuel filters are clogged

Aug 02, 2009 | 1992 Isuzu Trooper

2 Answers

Throttle body injectors not fiering but there is fuel pressure


the injectors are fired thru the engine cotrol module but it gets its signal to fire from the pick-up located inside the distributor if you are loosing injector pulse only the ignition module is bad if you are also loosing spark when you loose injector pulse your pick up is causing the problem if you replace the pick-up i recomend you change the ignition module when doing so because they work together and you have to remove the distributor to change the pick-up

May 31, 2009 | 1994 GMC Sierra

Not finding what you are looking for?
2002 Nissan Sentra Logo

1,045 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...