SOURCE: 1999 Chevy Venture, Windshield wipers stop in upright position
You will need to replace the wiper transmission.This is a common problem.
SOURCE: need to know how to replace the windshield wiper motor
First remove the wiper arms.Then remove the screws that hold the black plastic grill, you will see the motor.You will need then to disconnect the wiper arm transmission linkage from the motor, then remove the three bolts holding the motor on, dont't forget to disconnect the electrical connector from the motor.Install in reverse order.Good luck.
SOURCE: wheres the circuit board for a windshield wiper
Hello jlwhelchel: My name is Roger and I will answer your question. Raise the hood locate the wiper motor. Remove the cover held on by three screws. Remove the cover. The cover is the module.
Should you need further help please just ask. Please rate the answer. This way I know the information was helpful. Thank You for using Fix Ya. Roger
SOURCE: 2003 Chevy SuBurban The windshield wipers will not
It is actually a wiper control module that controls this. I have replaced many of them. It is the cover that is screwed to the wiper gear box. Remove both wiper arms. Remove the plastic cowl cover below the windshield that covers from side to side. Once inside you will see the wiper motor/transmission assy. Disconnect the electrical connector, and remove screws from cover, and replace it.
SOURCE: I have a 2003 Chevy Trailblazer Windshield Wiper problem.
As it turns out, there is a recall On 2002-2003 Chevy Trail Blazer's
Windshield Wiper/washer
NHTSA No. 04V046000
Recall Date: Feb, 4th, 2004
Call your dealer to see if this is still under the recall to be fixed.
RECALL: 2002 - 2003 Chevrolet Trailblazer
NHTSA Campaign Number:
04V046000
www.nhtsa.dot.gov
Manufacturer
GENERAL MOTORS CORP.
Recall Date:
FEB 02, 2004
Potential Number Of Units Affected:
581394
Description
VISIBILITY:WINDSHIELD WIPER/WASHER
Summary
CERTAIN SPORT UTILITY VEHICLES HAVE WINDSHIELD WIPER SYSTEMS THAT WILL NOT TURN ON, CEASE OPERATION WHILE IN USE, FAIL TO TURN OFF/ON BY THEMSELVES (MOISTURE SENSITIVE WIPER SYSTEM), OR HAVE CONTINUOUS WINDSHIELD WASHER PUMP OPERATION BECAUSE THE PRESENCE OF WATER WITHIN THE WIPER MODULES CAN EITHER CAUSE A SHORT CIRCUIT OR CAN LEAD TO THE CORROSION OF COMPONENTS WITHIN THE MODULE.
Consequence
DEPENDING ON THE OCCURRENCE AND WEATHER SITUATION, DRIVER VISIBILITY COULD BE REDUCED, WHICH COULD RESULT IN A CRASH.
Remedy
DEALERS WILL COVER THE WINDSHIELD WIPER MODULE VENT HOLE WITH A PATCH. ALSO, THE WIPER MOTOR, CIRCUIT BOARD, AND ELECTRICAL CONNECTOR WILL BE INSPECTED TO SIGNS OF WATER INTRUSION AND/OR CORROSION AND BE REPLACED AS REQUIRED. THE RECALL BEGAN JULY 6, 2004. OWNERS SHOULD CONTACT CHEVROLET AT 1-800-630-2438; OLDSMOBILE AT 1-800-630-6537; OR GMC AT 1-866-996-9463.
1,763 views
Usually answered in minutes!
×