2005 Toyota Highlander..passenger side mirror bracket

SOURCE: ECT snow feature Toyota Highlander 2005

Turn vehicle on, with foot on brake put vehicle in NEUTRAL. Still holding brakes move 4x4 switch to 4 wheel drive, it should engage. The ECT snow is just s feather that make the transmission take off in 2nd gear so its not a fast take off and you wouldn't skid. Good Luck

SOURCE: INSTALL SIDE VIEW MIRROR ON A 1997 TOYOTA CAMRY

Yes, you have to remove the door panel.

Remove the 2 plastic protectors on the front edge, and remove the 2 brass colored screws. Next, remove the push pins from the latch side. Push in, and pull out the whole thing. Next, under the armrest, remove the screw. Lift up the power windoe control, being careful to not break the plastic retainer tab. Remove the screw under the window control. Starting at the bottom, pull out the panel, and, when all of the clips are loose, pull the panel straight up. It is best to do this with the door panel as warm as possible, like in a heated garage. Doing this outside in the cold will break all of the plastic retainer clips; they are quite brittle whn cold.

I hope this helps

Thanks for choosing FIxYa for assistance. A FIxYa rating (4 blue diamonds) would be greatly appreciated.

SOURCE: Need to replace the broken outside right passenger mirror I have replacement

To repace the COMPLETE MIRROR UNIT, the inside door trim must be removed. Hope this helps

SOURCE: broken driver side view mirror-2005 camry

Heated mirrors usually have a symbol on them -- a small diagram showing squigley heat lines.

If you don't see this, it's probably not heated. But when you take the mirror off, if it's heated it'll have wires connected to the back.

Yes, you can replace a heated mirror with non-heated -- just leave the wires tucked out of the way when you install the new mirror.

SOURCE: 2008 Ford Fusion Wing Mirror Replacement

I checked Ford Focus mirror replacement and it seems to be the same. This is for the manual, unheated mirror.

Remove the mirror cover inside the door - slide a screwdriver behind the cover and pry loose carefully.

Remove the single 10mm bolt and the mirror comes free.
NB. Do not drop the bolt into the door.