Need diagram 1994 mitsubishi mirage 1.5 12 valve timing specs

SOURCE: where is my egr valve

Oks it should be close to fire wall it looks around 3 inches oval shaped and has 2 bolts in it and has a gasket plus it has a wired connector to it so you should replace the gasket after you clean it/ so tak it out and use carb cleaner any kind / Put an ew gasket on after you klean it and plug it back in try that/ Please rate my response/ Thank you very much

Greg Bernett

• 2993 Answers
• Posted on Mar 26, 2009

SOURCE: need engine specs for mitsubishi pajero 1996 3.5 lt 24 valve dohc

Here ya go....get the rest of the info right now.

SOURCE: i need to find a timing belt diagram for a 1994 mitsubishi galant

Your car will have the 2.4L SOHC engine in it (AKA 4G64). This manual will show you how to replace the timing belt (and more). Timing belt procedures start on page 33.

http://www.scribd.com/doc/4570538/Mitsubishi-4G63-4G64-Engine

(P.S. this manual also includes the 4G63 engine, you can identify your engine by looking at the procedures for the Single OverHead Cam[or SOHC])

Greg Bernett

• 2993 Answers
• Posted on Dec 07, 2009

SOURCE: how to install egr valve on 2000 mitsubishi mirage

1. Disconnect the negative battery cable.
   
2. Remove the air cleaner and intake hoses as required.
   
3. If necessary, detach the EGR temperature sensor connector.
   
4. Tag and disconnect the vacuum hose from the EGR valve.
   
5. Remove the mounting bolts and the EGR valve from the engine.
   
6. Clean the mating surfaces on the valve and the engine. Make sure to remove all gasket material.
   
7. Inspect the valve for a sticking plunger, caused by excess carbon deposits. If such a condition exists, clean with appropriate solvent so valve seats correctly.
   

1. Install EGR valve with a new gasket in place.
   
2. Install the mounting bolts and tighten as follows:
   
3. 1.5L, 1.6L, and 1.8L engines—7–10 ft. lbs. (10—15 Nm)
   
4. 2.0L engines—10–15 ft. lbs. (15—22 Nm)
   
5. 2.4L and 3.5L engines—16 ft. lbs. (22 Nm)
   
6. 3.0L engines—8 ft. lbs. (11 Nm)
   
7. Connect the vacuum hose to the EGR valve.
   
8. If detached, attach the EGR temperature sensor.
   
9. Install the air cleaner and air intake hoses as required.
   
10. Connect the negative battery cable.
    

SOURCE: My 1994 Mitsubishi Lancer (4g15) engine stops

Fuel pump

Testimonial: "It's the fuel pump indeed. Also the gas tank found to be very dirty. The fuel pump was replaced, fuel system cleaned, now the car runs perfectly."