Chevy oil filter stuck on - 2007 Toyota Sienna

Make sure the mating surface is clean, next lube the gasket in the oil filter with some fresh oil using your finger. Tighten 1 1/2 turns after gasket contacts. If this doesn't work it might not be the filter that's the problem...

make sure it doesn't have too gaskets stuck in there on the oil filter it wont seal up right.

You might try to change the trany filter and oil.

You're probably talking about a leak from the oil filter housing. If it is leaking you'll need to replace it. Otherwise - check your oil filter and where it mates on the housing and make sure you have a good seal with no extra gasket material stuck in the way.

the high pressure relief valve in the oil pump may be stuck. Be sure to use the correct weight oil (5 or 10w30) try it again, if it blows off, the valve is stuck, and disassembly may be required.

Take th oil filter off and make sure there is only one gasket sometimes the old one will stick there and the new ones cannot make a good seal

yes this is pretty comon should be around your oil filter area

remove the new filter, then remove the gasket from your old filter that is stuck to the engine, reinstall new filter

OOO not good sounds like some of the head gasket got stuck somewhere, or the gauge or sender is bad or got knocked around when repairing the head gasket. I would check that first. If that checks out will need to drop the pan to see if something got stuck in the pickup tube,might as well change the pump while you are there. Or worst case some thing wrong with gasket job impeading oil flow back to bottom of the engine. Was the oil and filter changed ?if so pull out filter and see if an chunks are stuck in it now. And change oil and filter again. Sorry that was out of order I had a long day

yes your oil pump pressure relief valve is stuck the oil pump has to come out.it is building way to much pressure.