At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
I have a 98 jeep grand cherokee 5.9L . no power at coil. got fuel pressur and engine turns over but i have no spark. changed coil / crank sensor / cam sensor and a used pcm. still no change.. any ideas???
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
code p 0307 is misfiring on no 7 cylinder ====causes --- engine mechanical fault ---wiring---ignition/ fuel system--injector --ECT/MAF sensor---ECM
look for low fuel pressure or ignition control module
See if your getting spark at the ign. coil first (passengers side on that year) if you are change the crank shaft sensor making sure you mount it as close to the engine as possible so it never gives you trouble again.
MAKE SURE DISTRIBUTOR CAP ,ROTOR, SPARKPLUGS AND WIRES, OKAY IF ALL HAS BEEN REPLACED.IF NOT GETTING SPARK PROBLEM COULD BE IGNITION COIL FAULTY, ASD RELAY FAULTY,DISTRIBUTOR WITH CAMSHAFT SENSOR FAULTY OR YOU HAVE FAULTY PCM. CODE SCAN VECHICLE FOR FAULT CODE, IF YOU ARE GETTING SPARK PROBLEM IN THE FUEL SYSTEM, CHECK FUEL PUMP RELAY AND FUSE MAKE SURE FUEL FILTER BEEN CHANGED AND FUEL PRESSURE IS 39 - 41 PSI. CHECK FOR FUEL SPARK SEE WHAT GOING ON, VECHICLE NEEDS FUEL OR SPARK TO RUN IF ONE NOT WORKING ENGINE WILL NOT START.
TRY THE PLUGS ,CAP&ROTOR CHANGE THE FUEL FILTER,STILL NO START,THEN CHECK THE FUEL FILTER NOW, IT SHOULD BE WET,IF NOT THEN YOUR FUEL PUMP IS NOT WORKING
Try resetting the asd "auto shut down fuse had a similar problem the jeep would crank but did not get spark or gas also check your fuel pump? and the asd relay may be bad it will prevent the jeep from getting no spark and will not fire some jeeps have security problems
have the crank sensor replaced this controls the spark and injector pulse it is located on the drivers back side of the engine above the transmission housing!
Back up a minute...Do you have spark from the coil wire? (juice from coil) If so, change or check rotor and cap (wires do not all go bad at same time so unless they are wet, likely at least good enough to start engine)
Car was running.now it is not have spark,compression, and fuel
×