Question about Cars & Trucks

1 Answer

Started car moved it out of the garage onto the drive all fine left for 30min and it would only turn over but not start,all checks done,battery,pump,fuel,plugs,all ok,put a diagnosis tool on and no fault code found local garage did the same with his machine and again no fault codes are showing but won't start,I'm at a loss please help..

Posted by Terry holmes on


1 Answer

John Gray

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    An expert who has answered 20 questions.

  • Expert
  • 109 Answers

Maybe some info like what type of car motor

Posted on Jul 10, 2013

  • Terry holmes
    Terry holmes Jul 10, 2013

    Sorry, its a Peugeot 306 52 plate 62k.



5 Related Answers



  • 2007 Answers

SOURCE: Loss of power Mitsubishi carisma 1.9 DiD 2002

Change fuel filter.

Posted on May 20, 2009


steve noel

  • 750 Answers

SOURCE: same as previous person

egr valve stock in open position,replace unit

Posted on Aug 07, 2009


  • 635 Answers

SOURCE: 2006 dodge grand caravan-car won;t start.

Test at the spark plug if you are getting current there with a cheap spark plug tester, if not, it could be the spark box. ( it used to be an ignition coil on older cars ) double check the computer for codes which may lead to a cam sensor not giving the PCM information.

Posted on Mar 30, 2010


Reynaldo Andico

  • 2431 Answers

SOURCE: Have a 1999 S10 Chev

You have a bad typical connection hence the code, you are mainy going to have to troubleshoot this one on you own Chevy are popular for good looking wire connection and poor contact especially on the coil area just wiggle the connection and have some one crank it and it will start then wiggle it again and it will stall out, 1351 here is the definition Ignition coil high circuit input what this means is your are internaly disconnected you will need a terminal repair on the ignition coil this is a typical failure on the connection

Posted on Jul 12, 2011

Pablo Gonzalez

  • 733 Answers

SOURCE: engine check light on while driving, already replace new fuel filter with regulator, clear fault using vw diagnosis tool, after driving several days, the fault occured again with the fault code p0441>

Your EVAP purge valve may be faulty. Also, check the vaccum lines attached to the valve for any signs of wear and tear. Should be located next to the coolant tank.

Posted on Nov 20, 2011

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I get code 51 on 1996 dodge caravan....fuel system lean---a lean air/fuel mixture has been indicated by an abnormally rich correction factor. The van runs fine when engine is cold but will sputter and...

the code is telling you where the problem is. Try replacing the HO2S sensors as the cpu is having trouble keeping the air /fuel mixture within limits. Check the cat converter for cracks or blockages . Have a pressure test done on the fuel manifold to check for pump/filter and pressure regulator problems. Check the ambient air temp sensor and coolant temp sensor as they also affect the air/fuel mixture.

Sep 23, 2013 | 1996 Dodge Caravan

1 Answer

I have a 2002 duramax 2500HD. the garage replaced the glow plugs because it would not start. Left the garage with it got it home and it once again won't start. Runs fine once started, no smoking at all, no...

you are getting air in the fuel sys. pump on top of filter push it several times until it gets a little resistance . then try to crank it may take a few seconds . it happens after hard driving or sitting for a while.

Feb 15, 2011 | 2001 Chevrolet Silverado 2500HD

1 Answer

I got in car all day to drive around an it was fine then a lil later I got in the car an started it an the battery lite came on drives it and all for a bout 30min an was still on Wat is wrong

sounds like your alternator is bad. most places check this for free and can do it in just minutes. have it checked and replace if necessary.

Sep 14, 2010 | 2008 Dodge Avenger

1 Answer

Fiat punto no spark wont start

check you camshaft position sensor 

Feb 01, 2009 | 1990 Buick Reatta

2 Answers

Car starts but it will not move.

i had the same problem with one of my cars and it came done to the shift selonoids in the transmision. I would have them test at a shop before you junk the car. hope this help ans thanks for using


Dec 18, 2008 | 1998 Chrysler Sebring

2 Answers

1996 tahoe won't start

try fittung a larger capacity battery this will help when you are parked for extended periods of time, but it does sound as if you have something draining the battery, try getting the alternater checked

Nov 15, 2008 | 1996 Chevrolet Tahoe

2 Answers

I was backing out of my drivewqay when i felt a catching like a rearend binding up. i went from drive to reverse and it continued for a while then i was able to get it into the garage. i jacked up the...

Sorry to tell you this really but there is not cheap fix. It needs a tranny shop and at minium will need a few gears and probably a clutch pack or too not too mention a complete cleaning and adjust service..AAMCO is reccomended

Aug 06, 2008 | 2003 GMC Sierra 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

85239 Answers

john h

Level 3 Expert

23504 Answers

Brad Brown

Level 3 Expert

18519 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides