BMW 5 series - 2005 model - resetting service & waring lights

Hello not sure if this will help but it should be close to what you need
https://www.youtube.com/watch?v=5eEZwqPR5Vg
BMW 5 Series Service Reset Brake Pad Reset Spark Plug Reset Oil Service...

the abs has nothing to do with brake pads. the abs runs on speed sensor on each tire. if your brake light is on all bmw have a wire in the brake pads for warning the brakes are low

Depending on what warning is on... if it's stating brake sensor then one has come loose or cable got pinched when re-installing. If it's ABS light that needs to be reset w/reset tool.

Firstly ( assuming you have replaced the brake pads) you MUST replace the wear sensor with a new one. Lower drivers window, With door closed, lean thro open window and put ignition on without starting, leave for 15 minutes minimum, switch off, then start car. If this fails and you are unable to cancel warning via I drive button, then an appropriate scan tool will be required.

Hi , if you turn the ignition on so that all the dash lights are on , do not start the engine and leave on for aprox 45 seconds the brake pad warning lights should go out, regards mark

Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car

You Can probably accomplish this yourself if you have a brake pad warning light or ABS/ASC light on you may need a BMW tech to reset the system to complete the job.

i have a bmw , 1 series, i have just put air in my tyres and there is now a warning light on the dashboard, have i over inflated my tyres?

this needs to be done with a european capable scan tool,check around to see if someone has this tool, no other way sorry

I dunno if this will work on your BMW, but on my BMW Z3 and M3, it was....

Turn the ignition key to position 2, but do NOT start the car. Wait for about 45 seconds and the brake warning message will be reset.

If it doesn't reset, then the brake sensor was damage. You will need to replace the brake sensor. It sounds like you replace the brake right after you saw the warning, so the brake sensor should be okay.