I just bought a Pajero with Engine Nr 4D56 and Chassis V24 with Automaitc transmission.
The gearbox do not change to last level / shift. it maeans 1 is ok, 2 is ok, 3 is okay but the last not enter and force the car at 80km/h at 3500 rotation.
What can be the problem? the diesel consumption is high and force the engine. I am desesperated.
Hey, i used to have that same same problem, it was the gearbox accelerator cable from the gearbox that goes to the fuel pump which was blocked. Try to check and see if it still doing movementsHey, i used to have that same same problem, it was the gearbox accelerator cable from the gearbox that goes to the fuel pump which was blocked. Try to check and see if it still doing movements
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Does it have an automatic transmission? Without bolting up the torque converter, but after mounting the transmission to the engine, can you rotate the torque converter? (If the torque converter rotates, you can bolt it up AFTER the transmission is mounted.) If not, your torque converter is not fully seated into the pump in the transmission. Be aware that you may have already damaged the pump if this is the case.
check the oil level of the gearbox, if level is low or oil is too thin will cause it to crunch. put an 80w90 gear oil into it if needs fill or change/ also check the clutch is fully disengaged. maybe clutch hydraulics have air in the system, this will reduce the travel of the clutch fork and not fully disengage the clutch. to see if its the clutch hydraulics select 1st gear push in the clutch and start the engine, if it starts to creep forward check out the hydraulics. if all this ok, prob be the synchro rings internal in the gearbox
an adaptor plate will be the solution to issue, google ( make of engine)+ adaptor plates. and you may find that an ad for supplier. holden engines are pretty common for conversions and their are plenty of engineering places that make adaptors.
Check overdrive relay. Its far left front in the glove compatmet.Its not going into overdrive. I had same issue went to left side of gearbox located od slonoid and rewired it.
Please,
I just bought a Pajero with Engine Nr 4D56 and Chassis V24
with Automaitc transmission.
The gearbox do not change to last level / shift. it maeans 1
is ok, 2 is ok, 3 is okay but the last not enter and force the car at 80km/h at
3500 rotation.
What can be the problem? the diesel consumption is high and
force the engine. I am desesperated.
4d56 is a diesel engine, fuel, oil, air filter change definitely,
regular oil change, check tyre pressure, etc all basic things u can do
yourself, after all its no 40+ MPG modern diesel engine its been around
for years and years and being used in courier van, pajero and delica, i
have a Delica with 4D56 turbo and its loves drinking diesel like no
tomorrow, run it on veggie oil like i do you wont worry too much about
your fuel consumption.
I have a pajero junior 1997 4A31, I am having problems, with my gear, when take off in D the car is slow, and up hill no power in 2nd & D, in Load ok. Plse advise. Thank you.
Does the engine turn over when you turn the key, if it doesnt it is the automatic park/neutral switch on the gearbox. This gets hot and the contacts seperate and no go. Remove the gearbox switch, pull apart and clean, when putting back together, put a bead of silicon across the joint and put back. It will keep running for ages.
Hey, i used to have that same same problem, it was the gearbox accelerator cable from the gearbox that goes to the fuel pump which was blocked. Try to check and see if it still doing movements
×